Lexus ES300 (1997 year). Manual — part 246
N21588
1
Wire Harness Side
e–1–1
N21589
1
2
N21589
2 1
N21590
Wire Harness Side
e–2–1
1
2
BE–48
–
BODY ELECTRICAL
INTERIOR LIGHT SYSTEM
1432
1997 LEXUS ES300 (RM511U)
8.
INSPECT DOOR COURTESY SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the con-
nector on the wire harness side.
Tester connection
Condition
Specified condition
1 – Ground
Constant
Battery positive voltage
If the circuit is not as specified, inspect power source or wire
harness.
9.
INSPECT LUGGAGE COMPARTMENT DOOR COUR-
TESY SWITCH CONTINUITY
Switch position
Tester connection
Specified condition
Switch OFF
–
No continuity
Switch ON
2 – Body Ground
Continuity
If continuity is not as specified, replace the switch and motor.
10.
INSPECT LUGGAGE COMPARTMENT DOOR OPEN-
ER MOTOR OPERATION
Connect the positive (+) lead from the battery to terminal 1 and
the negative (–) lead to body ground, check that the motor oper-
ates.
If operation is not as specified, replace the switch and motor.
11.
INSPECT LUGGAGE COMPARTMENT DOOR COUR-
TESY SWITCH AND OPENER MOTOR CIRCUIT
Disconnect the connector from the switch and opener motor,
and inspect the connector on the wire harness side.
–
BODY ELECTRICAL
INTERIOR LIGHT SYSTEM
BE–49
1433
1997 LEXUS ES300 (RM511U)
Tester connection
Condition
Specified condition
1 – Ground
Luggage compartment door opener switch OFF
No voltage
1 – Ground
Luggage compartment door opener switch ON
Battery positive voltage
2 – Ground
Constant
Battery positive voltage
If the circuit is not as specified, inspect power source or wire
harness.
12.
INSPECT ILLUMINATED ENTRY SYSTEM
(See integration relay circuit on page
)
Z19396
Stop Light Switch
Instrument Panel Junction Block
STOP Fuse
High–Mounted Stop Light
Light Failure Sensor
Stop Light
BE059–01
BE–50
–
BODY ELECTRICAL
STOP LIGHT SYSTEM
1434
1997 LEXUS ES300 (RM511U)
STOP LIGHT SYSTEM
LOCATION
BE05A–01
Z06565
1
2
3
4
4
2
1
3
Z06566
Wire Harness Side
1
2
3
4
eg–4–1
N21597
1
2
–
BODY ELECTRICAL
STOP LIGHT SYSTEM
BE–51
1435
1997 LEXUS ES300 (RM511U)
INSPECTION
1.
INSPECT STOP LIGHT SWITCH CONTINUITY
Switch position
Tester connection
Specified condition
Switch pin free
1 – 2
Continuity
Switch pin pushed in
3 – 4
Continuity
If continuity is not as specified, replace the switch.
2.
INSPECT STOP LIGHT SWITCH CIRCUIT
Disconnect the connector from the switch and inspect the con-
nector on the wire harness side.
Tester connection
Condition
Specified condition
2 – Ground
Constant
Battery positive voltage
If circuit is not as specified, inspect the power source or wire
harness.
3.
INSPECT HIGH–MOUNTED STOP LIGHT ASSEMBLY
CONTINUITY
Using the ohmmeter, check that continuity exists between ter-
minals.
If continuity is not as specified, replace the bulb or light assem-
bly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст