Lexus ES300 (1997 year). Manual — part 221
N22038
A – A
B – B
A
A
B
B
CANADA:
BO–66
–
BODY
WINDSHIELD
1244
1997 LEXUS ES300 (RM511U)
15.
CANADA:
INSTALL WINDSHIELD MOULDING
Place the moulding onto the body and tap it by hand.
16.
INSTALL THESE PARTS:
(a)
Front side of roof headlining
(b)
Roof console box
(c)
Cowl top ventilator louver
(d)
Hood to cowl top seal
(e)
Wiper arm and blades
Torque: 24 N·m (245 kgf·cm, 18 ft·lbf)
(f)
Front pillar garnishes
(g)
Sun visors and holders
BO0AH–04
N21845
N·m (kgf·cm, ft·lbf) : Specified torque
Non–reusable part
Stopper
Stopper
Back Window Moulding
Back Window Glass
Rear Seat Cushion
Rear Seatback
Roof Side
Inner Garnish
Rear Speaker Grille
Roof Side
Inner Garnish
Package Tray Trim
18 (185, 13)
–
BODY
BACK WINDOW GLASS
BO–67
1245
1997 LEXUS ES300 (RM511U)
BACK WINDOW GLASS
COMPONENTS
BO0AI–04
N21430
: 4Clips
N21407
N17178
BO–68
–
BODY
BACK WINDOW GLASS
1246
1997 LEXUS ES300 (RM511U)
REMOVAL
1.
REMOVE REAR SEAT CUSHION AND SEATBACK
(See page
)
2.
REMOVE ROOF SIDE INNER GARNISH
Remove the clip and garnish.
3.
REMOVE REAR SPEAKER GRILLE
(a)
Using a screwdriver, remove the rear speaker grille as
shown in the illustration.
HINT:
Tape the screwdriver tip before use.
(b)
Disconnect the connector.
4.
REMOVE PACKAGE TRAY TRIM
5.
REMOVE BACK WINDOW MOULDING
Using a knife, cut off the moulding as shown in the illustration.
NOTICE:
Do not damage the body with the knife.
6.
REMOVE BACK WINDOW GLASS
Remove the glass in the same way as windshield.
(See page
)
BO0AJ–04
N17193
–
BODY
BACK WINDOW GLASS
BO–69
1247
1997 LEXUS ES300 (RM511U)
INSTALLATION
HINT:
Refer to the installation of windshield and install the back win-
dow glass by following operations. (See page
1.
CLEAN AND SHAPE CONTACT SURFACE OF BODY
2.
REPLACE STOPPER
3.
CLEAN REMOVED GLASS
4.
POSITION GLASS
5.
CLEAN CONTACT SURFACE OF GLASS
6.
COAT CONTACT SURFACE OF BODY WITH PRIMER
”M”
7.
COAT CONTACT SURFACE OF GLASS WITH PRIMER
”G”
8.
APPLY ADHESIVE
9.
INSTALL GLASS
10.
INSPECT FOR LEAKS AND REPAIR
11.
APPLY ADHESIVE AT MOULDING INSTALLATION
AREA
12.
INSTALL BACK WINDOW MOULDING
Place the moulding onto the body and tap it by hand.
13.
INSTALL THESE PARTS:
(a)
Package tray trim
(b)
Rear speaker grille
(c)
Roof side inner garnish
(d)
Rear seat cushion and seatback
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст