Lexus SC300 / Lexus SC400. Manual — part 127
BUMPER
Front Bumper
COMPONENTS
–
BODY
Bumper (Front Bumper)
BO–11
REMOVAL OF FRONT BUMPER
(See page
1.
REMOVE FENDER SPLASH SHIELD
Remove fourteen screws, a bolt and the shield.
2.
REMOVE NO. 2 ENGINE UNDER COVER
Remove seven screws, five bolts and the cover.
3. REMOVE
HEADLIGHT
(Low Beam)
(a) Remove two nuts, a bolt and the headlight.
(b) Disconnect the connectors.
4.
REMOVE UPPER BUMPER RETAINER
(a) Remove the hood seal.
(b) Remove five screws and the retainer.
5.
REMOVE BUMPER COVER ASSY
(a) Remove six clips.
BO–12
–
BODY
Bumper (Front Bumper)
(b) Remove four clips.
(c) Remove the clip and ambient temperature sensor.
(d) Remove four nuts.
(e) Remove ten clips.
(f) Remove two bolts.
(g) Disconnect the connectors.
(h) Remove the bumper cover assy.
6. REMOVE
REINFORCEMENT
Remove six bolts and the reinforcement.
7.
REMOVE UPPER REINFORCEMENT
Remove eight bolts and the reinforcement.
8. REMOVE
HEADLIGHT
(High Beam)
(a) Remove two screws, a clip and the headlight.
(b) Disconnect the connector.
–
BODY
Bumper (Front Bumper)
BO–13
INSTALLATION OF FRONT BUMPER
(See page
INSTALL FRONT BUMPER PARTS BY FOLLOWING RE-
MOVAL SEQUENCE IN REVERSE
HINT:
•
When installing the bumper on the body, be careful
not to damage the serrated part of side bolts.
•
After installing the headlight, adjust the light aiming.
(See page
DISASSEMBLY AND ASSEMBLY OF
FRONT BUMPER
DISASSEMBLY AND ASSEMBLY BY
FOLLOWING PARTS:
(a) Cornering
lights
(b) Side turn lights
(c) Bumper energy absorber
(d) Retainers
(e) License
bracket
BO–14
–
BODY
Bumper (Front Bumper)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст