Lexus SC300 / Lexus SC400. Manual — part 945
AIR CONDITIONING EVAPORATOR
– AC001–97
September 12, 1997
ES 300
3.
Reinstallation of parts.
(’92–’96)
(Continued)
(a) Insert the filter (up side) into the
heater unit following the numbered
steps shown in the illustration.
(b) Insert the filter (down side) into the
heater unit.
(c) Reinstall the plate on the side of the
heater unit using steps
¬
and
Ë
,
indicated with
red
arrows to show
direction, in the illustration.
CAUTION:
Confirm that the plate is secure.
(d) Restore the carpet to its original
position taking care not to bend
the cable.
Page 4 of 11
Page 5 of 11
AIR CONDITIONING EVAPORATOR ODOR
– AC001–97
September 12, 1997
GS 300
1.
Removal of parts.
(a) Remove the undercover.
NOTE:
Pull down the clip areas (3 places) of
the Undercover to remove.
(b) Remove the lamp.
(c) Remove the (2) wing nuts and the
plate on the bottom of the cooling
unit.
CAUTION:
The plate and wing nuts will be reused.
(d) Remove the (2) filters from the cooling
unit.
2.
Clean the Evaporator.
S
Follow the general procedures given on
page 2.
NOTE:
Location for insertion of spray nozzle is
indicated by the
red
arrow in the
illustration.
AIR CONDITIONING EVAPORATOR ODOR
– AC001–97
September 12, 1997
GS 300
3.
Reinstallation of parts.
(Continued)
(a) Insert the (2) filters into the cooling
unit as shown in the illustration.
NOTE:
Insert a clean air filter with it’s knob
facing downwards, then slide it forward
and install the second filter in the same
manner.
(b) Assemble the rubber insulator on the
plate.
CAUTION:
To prevent the cooling unit from leaking
water, pull the three rubber projections
from the other side of the plate to make
sure that the rubber insulator seals
properly against the plate.
(c) Install the plate on the cooling unit
and secure with the (2) wing nuts.
CAUTION:
To prevent water leaks, verify that the
cooling unit and plate are fully secure
before tightening the wing nuts.
NOTE:
Before installing the plate on the cooling
unit, coat the rubber insulator with water
for easier assembly.
(d) Reinstall the lamp.
(e) Reassemble the Undercover.
Page 6 of 11
Page 7 of 11
AIR CONDITIONING EVAPORATOR ODOR
– AC001–97
September 12, 1997
LS 400
1.
Removal of parts.
(’93–’94)
(a) Remove the undercover.
NOTE:
S
Remove the front of “A” clips.
S
Pull down the three “B” clip areas
of the Undercover to remove.
(b) Remove the lamp.
(c) Remove the (2) wing nuts and the plate
on the bottom of the cooling unit.
CAUTION:
The plate and wing nuts will be reused.
(d) Remove the (2) filters from the cooling
unit.
2.
Clean the Evaporator
S
Follow the general procedures given on
page 2.
NOTE:
Location for the insertion of spray
nozzle is indicated by the
red
arrow
in the illustration.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст