Lexus SC300 / Lexus SC400. Manual — part 804
DIFFERENTIAL REMOVAL
SA0S6–05
1.
REMOVE PROPELLER SHAFT
(See page
)
2.
DRAIN DIFFERENTIAL OIL
3.
DISCONNECT REAR DRIVE SHAFTS
(a) Place matchmarks on the drive shafts and side gear shafts.
(b) Using a hexagon wrench, disconnect the drive shafts from
the differential.
(c) Hang up the drive shafts using wire, etc.
4. REMOVE
DIFFERENTIAL
(a) Support the differential with a jack.
(b) Using a hexagon wrench, remove the 3 bolts.
(c) Remove the 2 bolts and lower stoppers.
(d) Remove the differential.
SA–82
–
SUSPENSION AND AXLE
REAR DIFFERENTIAL
(e) Remove the upper mount stopper from the differential carrier.
HINT:
•
Same vehicles have the adjusting shim for adjusting the
propeller shaft joint angle installed on top of the upper
mount stopper.
•
Adjusting shim is not always as it is used upon need.
DIFFERENTIAL INSTALLATION
SA0S7–06
1. INSTALL
DIFFERENTIAL
(a) Install the upper mount stopper on the differential carrier.
HINT:
•
Use the upper mount stopper which was removed.
•
On vehicles with the adjusting shim installed on top of
the mount upper stopper, install that adjusting shim.
•
Adjusting shim is not always as it is used upon need.
(b) Support the differential with a jack and install the lower
stoppers and 2 new bolts.
Torque: 147 N
⋅
m (1,500 kgf
⋅
cm, 108 ft
⋅
lbf)
(c) Using a hexagon wrench, install 2 new LH mounting bolts.
Torque: 142 N
⋅
m (1,450 kgf
⋅
cm, 105 ft
⋅
lbf)
(d) Using a hexagon wrench, install a new RH mounting bolt.
Torque: 142 N
⋅
m (1,450 kgf
⋅
cm, 105 ft
⋅
lbf)
–
SUSPENSION AND AXLE
REAR DIFFERENTIAL
SA–83
2.
CONNECT REAR DRIVE SHAFTS
(a) Align
the matchmarks on the side gear shaft and drive shafts.
(b) Apply a light coat of engine oil on the threads of the bolts.
(c) Temporarily install the 12 hexagon bolts and 4 washers.
(d) Using a hexagon wrench, torque the bolts.
Torque: 83 N
⋅
m (850 kgf
⋅
cm, 61 ft
⋅
lbf)
3.
INSTALL PROPELLER SHAFT
(See page
4.
FILL DIFFERENTIAL WITH OIL
Oil grade:
API GL–5 Hypoid Gear Oil
Viscosity:
Above–18
C (0
F) SAE 90
Below–18
C (0
F) SAE 80W–90 or 80W
Capacity:
1.35 liters (1.42 US qts, 1.19 lmp qts)
SA–84
–
SUSPENSION AND AXLE
REAR DIFFERENTIAL
DIFFERENTIAL CARRIER
COMPONENTS
SA0V2–01
–
SUSPENSION AND AXLE
REAR DIFFERENTIAL
SA–85
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст