Lexus SC300 / Lexus SC400. Manual — part 863
OK
NG
OK
NG
4
Check voltage between terminals IGT1, 2 of engine and & ECT ECU connector and body ground.
C
OK
P
Connect the Check Harness A.
(See page
Measure voltage between terminals IGT1, 2 of engine
& ECT ECU connector and body ground when engine
is cranked.
Voltage:
0.5 – 1.0 V
(Neither 0 V nor 5 V)
Go to step [9].
5
Check voltage between terminal 3 of No. 1, No. 2 igniter connectors and body ground.
C
OK
P
Disconnect igniter connector.
Mesure voltage between terminal 3 of No. 1, No. 2 igni-
ter connectors and body ground, when ignitino switch is
turned to “ON” and “STA” position.
Voltage:
10 – 14 V
Go to step [8].
–
ENGINE TROUBLESHOOTING
Circuit Inspection
TR–57
OK
NG
OK
NG
6
Check for open and short in harness and connector between ignition relay and ignition coil,
ignition coil and igniter (See page
).
Repair or replace harness or connector
#
Check ignition coil.
C
OK
P
Disconnect ignition coil connector.
(For No. 1 ignition coil (on left bank), remove the battery)
(2) Check primary coil.
Measure resistance between terminals of ignition
coil connector.
(2) Check secondary coil.
Measure resistance between terminal 1 of ignition
coil connector and high–tension terminal.
Replace ignition coil.
Replace Igniter. *1
*1:
When diag. code 14 is displayed, replace the igniter with
5 wire harness. (extra wire is for tachometer). When diag.
code 15 is displayed, replace the igniter with 4 wire har-
ness
TR–58
–
ENGINE TROUBLESHOOTING
Circuit Inspection
OK
NG
8
Check Ignition Relay.
C
OK
P
C
OK
Remove ignition relay.
Check continuity between terminals of ignition relay
shown below.
(2) Apply battery voltage between terminals 3 and 6, 4
and 5.
(2) Check continuity between terminals 1 and 2.
Replace ignition relay.
Check and repair harness or connector between
battery and ignition relay, ignition relay and igni-
ter.
–
ENGINE TROUBLESHOOTING
Circuit Inspection
TR–59
NG
OK
OK
NG
9
Disconnect igniter connector and check voltage between terminals IGT1, 2 of engine & ECT
ECU connector and body ground.
C
OK
P
Disconnect igniter connector.
Connect engine & ECT ECU connector.
Measure voltage between terminals IGT1, 2 of engine
& ECT ECU connector and body ground when engine
is cranked.
Voltage:
0.5 – 1.0 V
(Neither 0 V nor 5 V)
Replace igniter .*1
10
Check for Open and short in harness and connector in IGT signal circuit between engine & ECT
ECU and igniter (See page
Repair or replace harness or connector.
Check and replace engine & ECT ECU.
*1:
When diag. code 14 is displayed, replace the igniter with
5 wire harness. (extra wire is for tachometer). When diag.
code 15 is displayed, replace the igniter with 4 wire har-
ness
TR–60
–
ENGINE TROUBLESHOOTING
Circuit Inspection
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст