Lexus SC300 / Lexus SC400. Manual — part 239
OK
NG
10
Check main throttle position sensor (See page EG–609 or
Adjust or replace main throttle position sensor (See
page
Check and replace ECM.
–
BRAKE SYSTEM
TRACTION CONTROL SYSTEM (TRAC)
BR–207
DTC
47, 48 Sub–Throttle Position Sensor Circuit
CIRCUIT DESCRIPTION
This sensor detects the opening angle of the sub–throttle valve and sends the appropriate signals to the ECU.
If a trouble signal is input, the ECU prohibits TRAC control.
DTC No.
DTC Detecting Condition
Trouble Area
47
When any of the following (1) through (3) is detected:
(1) Deviation of 5 steps or more to the closedside of
the idle step during sub–throttleinitial check.
(2) Voltage at terminal IDL2 switch is OFF evenafter
sub–throttle is driven to fully closedposition during
sub–throttle initial check 4.
(3) Voltage at terminal VSH is 1.45 V or morefor at
least 0.15 sec. while idle switch is ON.
Sub–throttle position sensor
Open or short in IDL2 circuit
ECM
TRAC ECU
48
Either of the following (1) or (2) continues for atleast
0.12 sec.
(1) Input voltage of TRAC ECU terminal VSH:4.3 V or
more.
(2) Input voltage of TRAC ECU terminal VSHis 0.2 V
or less while IDL2 switch OFF.
Sub–throttle position sensor
Open or short in VSH circuit
ECM
TRAC ECU
BR–208
–
BRAKE SYSTEM
TRACTION CONTROL SYSTEM (TRAC)
).
).
).
DIAGNOSTIC CHART
DIAGNOSTIC CHART
–
BRAKE SYSTEM
TRACTION CONTROL SYSTEM (TRAC)
BR–209
WIRING DIAGRAM
BR–210
–
BRAKE SYSTEM
TRACTION CONTROL SYSTEM (TRAC)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст