Lexus SC300 / Lexus SC400. Manual — part 749
(c) Place matchmarks on the intermediate shaft and control
valve shaft.
(d) Loosen the bolt on the upper side of the intermediate shaft,
remove the bolt on the lower side and disconnect the
intermediate shaft.
2.
DISCONNECT TIE ROD ENDS
(a) Remove the cotter pin and nut.
(b) Using SST, disconnect the tie rod end from the knuckle arm.
SST 09628–62011
3. CONNECT
INTERMEDIATE
SHAFT
(a) Set the gear housing so that it matches the dimensions
shown below, with the gear housing at the center point.
(b) Align
matchmarks on the intermediate shaft and control valve
shaft and connect them.
Torque: 35 N
⋅
m (360 kgf
⋅
cm, 26 ft
⋅
lbf)
SR–146
–
STEERING
POWER STEERING
4.
CONNECT PRESSURE AND RETURN TUBES
After inserting the rotation stopper in the valve housing holes,
tighten the union bolts.
Torque: 46 N
⋅
m (500 kgf
⋅
cm, 36 ft
⋅
lbf)
5.
CENTER SPIRAL CABLE
If the steering wheel has been removed, or the steering
wheel may have moved during the operation, always perform
centering of the spiral cable.
(See page
6.
CHECK STEERING WHEEL CENTER POINT
7.
BLEED POWER STEERING SYSTEM
(See page
)
8. CHECK
TOE–IN
(See page
)
–
STEERING
POWER STEERING
SR–147
COMPONENTS
SR0GJ–02
SR–148
–
STEERING
POWER STEERING
SECTIONAL VIEW
SR0GK–01
–
STEERING
POWER STEERING
SR–149
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст