Lexus SC300 / Lexus SC400. Manual — part 399
3.
DISCONNECT ENGINE WIRE FROM TRANSMISSION
(a) Disconnect the following connectors:
(1) O/D direct clutch speed sensor connector
(2) No.1 speed sensor connector
(3) No.2 speed sensor connector
(4) Neutral start switch connector
(b) Disconnect
the five wire clamps from the brackets on the
transmission.
4.
SEPARATE ENGINE AND TRANSMISSION
(See AT section)
EM–130
–
ENGINE MECHANICAL
Cylinder Block
COMPONENTS FOR DISASSEMBLY AND ASSEMBLY OF CYLINDER BLOCK
–
ENGINE MECHANICAL
Cylinder Block
EM–131
PREPARATION FOR DISASSEMBLY
(See Components on page
)
1.
REMOVE DRIVE PLATE
Remove the eight bolts, two spacers and drive plate.
2. INSTALL ENGINE TO ENGINE STAND FOR
DISASSEMBLY
3.
REMOVE TIMING BELT AND PULLEYS
(See pages
to 44)
4.
REMOVE Cylinder Block
(See pages
to 75)
5.
REMOVE RH ENGINE MOUNTING BRACKET
Remove the four bolts and mounting bracket.
6.
REMOVE LH ENGINE MOUNTING BRACKET
(a) Remove the clamp bolt, and disconnect the engine wire
from the engine mounting bracket.
(b) Remove the four bolts and mounting bracket.
7. REMOVE
STARTER
(a) Remove the two bolts, and disconnect the starter from
the cylinder block.
EM–132
–
ENGINE MECHANICAL
Cylinder Block
(b) Disconnect the wire clamp from the bracket on the
starter.
(c) Remove the nut, and disconnect the wire.
(d) Disconnect the connector, and remove the starter.
8.
REMOVE KNOCK SENSORS
(a) Disconnect the two knock sensor connectors.
(b) Using SST, remove the two knock sensors.
SST 09816–30010
9. REMOVE
WATER
BY–PASS
PIPE
(a) Remove the two bolts.
(b) Pull out the by–pass pipe from the water pump.
(c) Remove the O–ring from the by–pass pipe.
10. REMOVE ENGINE WIRE
(a) Disconnect the following connectors:
(1) Oil level sensor connector
(2) Oil pressure switch connector
(b) Remove the three bolts and wire cover from the LH side
of the cylinder block.
(c) Remove the two bolts and engine wire.
–
ENGINE MECHANICAL
Cylinder Block
EM–133
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст