Lexus SC300 / Lexus SC400. Manual — part 759
SECTIONAL VIEW
SR0EQ–02
–
STEERING
STEERING COLUMN
SR–13
STEERING COLUMN DISASSEMBLY
SR0ER–03
NOTICE: When placing the breakaway bracket in a vise
during disassembly or assembly of the steering column,
use aluminum, etc. to prevent scratches to the tip of the
capsule.
1.
REMOVE IGNITION KEY CYLINDER ILLUMINATION
2.
REMOVE SLIDING YOKE
Place matchmarks on the sliding yoke and main shaft.
3.
REMOVE LOWER DUST COVER
(a) Remove the clip and dust cover.
(b) Using a screwdriver, remove the dust seal.
4.
REMOVE COLUMN UPPER BRACKET
(a) Using a centering punch, mark the center of the 2
tapered–head bolts.
(b) Using a 4–5 mm (0.16–0.20 in.) drill, drill into the 2
tapered–head bolts.
(c) Using a screw extractor, remove the 2 tapered–head bolts.
(d) Remove the bracket and column upper clamp.
SR–14
–
STEERING
STEERING COLUMN
5.
REMOVE TURN SIGNAL BRACKET
6. REMOVE
PROTECTOR
7. REMOVE
CONNECTOR
BRACKET
8. REMOVE TELESCOPIC LEVER SERRATION
ATTACHMENT
Remove the nut and the serration attachment.
9.
REMOVE TELESCOPIC LEVER
(a) Remove the bolt, collar, lever and washer.
(b) Remove the ball and compression spring.
–
STEERING
STEERING COLUMN
SR–15
10. REMOVE TELESCOPIC LEVER LOCK BOLT
Install a double nut on the lock bolt, then remove the lock bolt.
11. REMOVE
BREAKAWAY
BRACKET
(a) Remove the steering column tube stopper bolt.
(b) Using snap ring pliers, remove the snap ring from the main
shaft.
(c) Remove the breakaway bracket from the main shaft.
Be careful the spline part of the main shaft does not come
loose.
12. REMOVE 2 LOCK WEDGES FROM BREAKAWAY
BRACKET
13. REMOVE STEERING SHAFT THRUST STOPPER
14. REMOVE COMPRESSION SPRING
(a) Using a torx wrench, remove the bolt and spring.
Torx wrench: T30 (Part No. 09042–00010 or locally manufac-
tured tool)
(b) Remove the 2 bushings from the spring.
SR–16
–
STEERING
STEERING COLUMN
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст