Mercedes-Benz ML320. Manual — part 109
263
Practical hints
Unlocking/locking in an emergency
왘
Pull off battery cover 2 in direction of
arrow.
왘
Remove the batteries.
왘
Using a lint-free cloth, insert new bat-
teries under the contact spring with the
plus (+) side facing up.
왘
Press battery cover 2 onto housing
until locked in place.
왘
Push each button to assure proper op-
eration of the remote control.
If remote control does not function cor-
rectly after replacing the batteries, the
system may have to be resynchronized.
Synchronizing remote control
왘
Turn key in steering lock to position 2
(
컄
page 33), then to position 0 and re-
move.
왘
Within ten seconds, push and hold
button
‹ while pushing
button
Œ five times.
왘
Release the button, and press
‹,
Œ or Š once.
The remote control is resynchronized.
왘
Recheck all of the remote control func-
tions.
Fuel filler flap
1 Cover
2 Lock rod
왘
Open the tailgate.
왘
Open cover 1 in cargo area behind
the left trim panel.
왘
Turn lock rod 2 clockwise (arrow) to
the end stop.
The fuel filler flap can now be opened.
i
If it is not possible to resynchronize the
remote control, have the system
checked at your authorized
Mercedes-Benz Light Truck Center.
264
Practical hints
Unlocking/locking in an emergency
Manually unlocking the transmission
gear selector lever
In the case of power failure the transmis-
sion gear selector lever can be manually
unlocked, e.g. to tow the vehicle.
1 Pin
왘
Insert a pin 1, e.g. ball point pen, into
the covered opening below the
position D of the shift pattern.
왘
Perform the following two steps simul-
taneously:
왘
Push the pin down.
왘
Move gear selector lever from
position P.
왘
Remove pin 1.
The cover returns to its closed position
after moving the gear selector lever to
position D.
i
The gear selector lever is locked again
when moving it to position P.
265
Practical hints
Opening/closing in an emergency
왔
Opening/closing in an emergency
Sliding/pop-up roof*
You can open or close the sliding/pop-up
roof manually should an electrical malfunc-
tion occur.
The sliding/pop-up roof drive is located
behind the cover between the front interior
lamps.
1 Hexagon drive hole
2 Crank
3 Cover
왘
Pry off cover 3 using a flat blade
srewdriver.
왘
Obtain crank 2.
왘
Insert crank 2 through hole.
왘
Turn crank 2 clockwise to:
앫
slide roof closed
앫
raise roof at the rear
왘
Turn crank 2 counterclockwise to:
앫
slide roof open
앫
lower roof at the rear
The sliding/pop-up roof must be synchro-
nized if it has been operated manually
(
컄
page 149).
i
Push crank 2 upward while turning it,
to disengage the electric motor.
266
Practical hints
Replacing bulbs
왔
Replacing bulbs
Safe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp as-
semblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See your autho-
rized Mercedes-Benz Light Truck Center
for headlamp adjustment.
Bulbs
Front lamps
i
If the headlamps are fogged up on the
inside as a result of high humidity, driv-
ing the vehicle a distance should clear
out the fogging.
Lamp
Type
1 Fog lamp
H8 (35 W)
2 High beam
H7 (55 W)
3 Low beam
H7 (55 W)
Xenon* D2S-35 W
4 Turn signal,
parking, stand-
ing and side
marker lamp
1157 NA
(32/3 cp bulb)
5 Additional turn
signal
LED
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст