Mercedes-Benz ML320. Manual — part 17
Fig. 5: Hand Held Tester Graphic Information (2000 Models)
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
FAULT CODES
Fig. 6: Diagnostic Trouble Code (DTC) Memory (2000 Models-1 Of 4)
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
2001 Mercedes-Benz ML320
2000-01 ACCESSORIES/SAFETY EQUIPMENT Mercedes-Benz - Air Bag Restraint Systems
me
Fig. 7: Diagnostic Trouble Code (DTC) Memory (2000 Models-2 Of 4)
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig. 8: Diagnostic Trouble Code (DTC) Memory (2000 Models-3 Of 4)
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
2001 Mercedes-Benz ML320
2000-01 ACCESSORIES/SAFETY EQUIPMENT Mercedes-Benz - Air Bag Restraint Systems
me
Fig. 9: Diagnostic Trouble Code (DTC) Memory (2000 Models-4 Of 4)
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
CLEARING FAULT CODES
Connect Hand-Held Tester (965 589 00 01) to Data Link Connector (DLC). DLC is located in right rear corner
of engine compartment. It may be necessary to use Adapter (965 589 00 40 or 965 589 00 50) to connect HHT
to DLC. After HHT displays module number and version, press return key to start sequence. Using HHT,
follow HHT prompts to clear SRS fault codes. SRS codes are clear when ignition is turned on and SRS warning
light functions normally. See SYSTEM OPERATION CHECK .
UNDERSTANDING DIAGNOSTIC CHART INFORMATION
SRS & ETR Diagnosis Chart Column Identification
First column of chart identifies TEST STEP (1.0 for example). See Fig. 10 . Second column of chart identifies
HHT fault code (017, 003 for example). First code in column is for vehicles without side air bags. Second code
in column (when listed) is for vehicles with side air bags only. Other 5 columns are self-explanatory.
Using SRS & ETR Diagnosis Chart
For reading and understanding fault code diagnosis chart, use the following example: Read test step 3.0 (first
column), HHT fault Code 002, 004 (second column). See Fig. 10 . Read TEST SCOPE-HHT ACTUAL
VALUE NO.-TEXT column (third column). Driver-side air bag squib connector R12-3 is being tested. HHT
will identify if problem is with too much resistance or not enough resistance in driver-side air bag squib circuit.
Read TEST CONDITION column (fifth column). Test circuit with HHT connected to DLC, with ignition in
position "2". Read NOMINAL VALUE-HHT DISPLAY column (sixth column). HHT will display a check or
an "F". If HHT displays a check, circuit is okay. If HHT displays an "F", go to step 3.1.
Read TEST CONNECTION (NOT FOR HHT) column (forth column). Driver-Side air bag squib connector
R12-3, terminals No. 1 and 2 are identified. Read TEST CONDITION column. Test circuit with HHT
connected to DLC and ignition key removed. Remove driver-side air bag module. Disconnect driver-side air
bag module squib connector R12-3. Connect Resistance Substitution Unit (124 589 09 63) to driver-side air bag
module squib connector (harness side). Set resistance substitution unit to 2 ohms. Turn ignition key to position
"2". Read NOMINAL VALUE-HHT DISPLAY column. If HHT displays a check, replace driver-side air bag
NOTE:
Refer to table to properly identify components or connectors being tested. See
COMPONENT IDENTIFICATION table.
2001 Mercedes-Benz ML320
2000-01 ACCESSORIES/SAFETY EQUIPMENT Mercedes-Benz - Air Bag Restraint Systems
me
module. If HHT displays an "F", go to step 3.2.
Read TEST CONNECTION (NOT FOR HHT) column. Horn-air bag clockspring connector A45x1, terminals
No. 1 and 2 are identified. Read TEST CONDITION column. Test circuit with HHT connected to DLC.
Remove ignition key. Connect Resistance Substitution Unit (124 589 09 63 00) to horn-air bag clockspring
connector A45x1. Set resistance substitution unit to 2 ohms. Read NOMINAL VALUE-HHT DISPLAY
column. If HHT displays a check, check horn-air bag clockspring for continuity. Replace horn-air bag
clockspring as necessary. If HHT displays an "F", go to step 3.4.
MODEL IDENTIFICATION
COMPONENT IDENTIFICATION
NOTE:
Some testing is identified by model number. Refer to table to identify models by
model number. See MODEL IDENTIFICATION table.
Model Number
Model
129
SL Class
140
S Class
163
M Class
170
SLK Class
202
C Class
203
C 240 & C 320
208
CLK Class
210
E Class
215
CL 500
220
S 430 & S 500
Component
Manufacturer's Designation
A1e15
SRS warning light
A45
Horn-air bag clockspring
A53
Driver-side air bag sensor
A54
Passenger-side air bag sensor
B41-1
Passenger-side seat occupied recognition sensor
N2-2
SRS control module
N2-7
SRS control module
N72e1
Automatic child seat recognition light
R12-1
Driver-side ETR squib connector
R12-2
Passenger-side ETR squib connector
R12-3
Driver-side air bag squib connector
R12-8
Passenger-side air bag squib connector
R12-9
Side air bag (driver-side) squib connector
R12-10
Side air bag (passenger-side) squib connector
R12-20
Passenger-side air bag squib
2001 Mercedes-Benz ML320
2000-01 ACCESSORIES/SAFETY EQUIPMENT Mercedes-Benz - Air Bag Restraint Systems
me
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст