Mercedes-Benz ML320. Manual — part 118

299

Technical data

Weights

왔

Weights

Roof load max.

220 lbs (100 kg)

300

Technical data

Fuels, coolants, lubricants etc.

왔

Fuels, coolants, lubricants etc.

Capacities

Vehicle components and their respective
lubricants must match.

Therefore use only brands tested and
approved by Mercedes-Benz.

Please refer to the Factory Approved
Service Products pamphlet, or inquire at
your Mercedes-Benz Light Truck Center.

Model

Capacity

Fuels, coolants, lubricants etc.

Engine with oil filter

ML 350, ML 500

8.5 US qt (8.0 l)

Approved engine oils

Automatic transmis-
sion

9.0 US qt (8.5 l)

MB Automatic Transmission Oil

Transfer case

1.6 US qt (1.5 l)

(Dexron 3 or Dexron 2E)

Rear axle

1.3 US qt (1.25 l)

(Hypoid gear oil SAE 90, 85 W 90)

Front axle

1.2 US qt (1.1 l)

(Hypoid gear oil SAE 90)

Power steering

approx. 0.65 US qt (0.6 l)

MB Power Steering Fluid

Front wheel hubs

approx. 1.5 oz (43 g) each

High temperature roller bearing grease

301

Technical data

Fuels, coolants, lubricants etc.

Model

Capacity

Fuels, coolants, lubricants etc.

Cooling system

approx. 12.7 US qt (12.0 l)

MB Anticorrosion/Antifreeze

Fuel tank

ML 350, ML 500

22.0 US gal (83.0 l)

Premium unleaded gasoline:
Posted Octane 91 (Avg. of 96 RON/86 MON

including a reserve of

approx. 3.2 US gal (12.0 l)

Air conditioning system

R-134a refrigerant and special PAG lubricant
oil (never R-12)

Windshield washer and
headlamp cleaning
system*

8.0 US qt (7.6 l)

MB Windshield Washer Concentrate

1

1

Use MB Windshield Washer Concentrate “S” and water for temperatures above freezing or MB Windshield Washer Concentrate “S” and commercially available pre-
mixed windshield washer solvent/ antifreeze for temperatures below freezing. Follow suggested mixing ratios (

컄 page 307).

302

Technical data

Fuels, coolants, lubricants etc.

Engine oils

Engine oils are specifically tested for their
suitability in our engines. Therefore, use
only engine oils approved by
Mercedes-Benz. Information on approved
engine oils is available in the Factory
Approved Service Products pamphlet, or at
your authorized Mercedes-Benz Light
Truck Center.

Engine oil additives

Do not blend oil additives with engine oil.
They may damage the engine.

Damage or malfunctions resulting from
blending oil additives are not covered by
the Mercedes-Benz Limited Warranty.

Air conditioning refrigerant

R-134a (HFC) refrigerant and special PAG
lubricating oil is used in the air condition-
ing system.

Never use R-12 (CFC) or mineral-based lu-
bricating oil. Otherwise damage to the
system will occur.

Brake fluid

During vehicle operation, the boiling point
of the brake fluid is continuously reduced
through the absorption of moisture from
the atmosphere. Under extremely strenu-
ous operating conditions, this moisture
content can lead to the formation of bub-
bles in the system, thus reducing the sys-
tem’s efficiency.

Therefore, the brake fluid must be re-
placed every two years, preferably in the
spring.

Only brake fluid approved by
Mercedes-Benz is recommended. Your au-
thorized Mercedes-Benz Light Truck
Center will provide you with additional in-
formation.

!

Always check the oil filler cap
(

컄

page 221) for important information

pertaining to the engine oil needing to
meet a specific Mercedes-Benz specifi-
cation (e.g. MB 229.5). If such informa-
tion is printed on the oil filler cap, only
use an engine oil from the list of ap-
proved engine oils in the Factory Ap-
proved Service Products pamphlet that
meets the specification indicated on
the oil filler cap.

Using engine oils of other specification
may cause the FSS to incorrectly deter-
mine the next service interval and will
result in engine damage not covered by
the Mercedes-Benz Limited Warranty.