Mercedes-Benz ML320. Manual — part 313
10.
1. Insert red relay module (8) for power supply cable in position 7 in fuse unit (7).
Only on vehicles on which running boards are installed
2. Remove cable and fuse from red relay module (8) and install in free locations of present red replay
module in position 7 of fuse unit (7).
11. Insert attached 10 A fuse into fuse holder with voltage supply cable.
12. Unscrew nut (9) at terminal 31.
Fig. 304: Identifying Fuse Holder, Red Relay Module And Black Relay Module
13. Connect ground cable (10) of the interface module wiring harness to terminal 31.
14. Install nut (9) on terminal 31.
15.
1. Insertblack relay module (11) into location 9 of fuse unit (7).
Only if relay is not yet present.
16. Install fuse unit cover in right-side footwell.
RETROFIT VEHICLE VIDEO SYSTEM - AZ82.60-P-0004A
MODELS 163.136 /154 /172 1A as of 145273, 163.136 /154 /172 1X as of 708319,
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
163.113 /128 /157 /174 /175 1#
left hand drive vehicle
Fig. 305: Identifying Vehicle Video System Components
Fig. 306: Identifying Vehicle Antenna Cable And Self-Adhesive Foamed Material
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
Fig. 307: Identifying Wiring Harness For Auxiliary Interface Module And Clip
Fig. 308: Identifying Auxiliary Interface Module Connector And Mount For Center Console
Remove
1
Remove center console
Remove/install center
console
AR68.20-P-2000GH
2
Remove center console
insulating mat
3
Remove rear air duct
Up to VIN A289564,
X754619. 2 screws at
rear air duct.
4
Remove radio (A2)
Remove/install radio
AR82.60-P-7502EA
5
Remove glove
compartment
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
Remove/install glove
compartment
AR68.10-P-1400GI
Torx bit set
Fig. 309
6
Loosen upper section of
right front door rubber
seal
7
Remove A-pillar paneling
on right
Remove/install paneling
on A-pillar
AR68.30-P-4050GH
Long wedge
Fig. 155
8
Remove right sun visor
Remove/install sun visor
AR68.60-P-5480GH
9
Remove right front
handle
Open covers for
handles, press down clip
on each side of handle, at
the same time press
handle upward and pull
out.
10
Remove edge guard for
tilting/sliding roof cutout
11
Release upper right B-
pillar paneling
12
Remove covers at lower
rear seat
Do NOT remove
center cover for lower
40% seat. Do NOT
reinstall curtain on 60%
front bench seat.
Remove and install cover
on bottom of rear seat
AR91.12-P-1100GH
13
Release side shade at the
60% bench
Fold shade upward so
that the working area is
not obstructed.
14
Remove 40% rear seat
Remove and install bench
AR91.12-P-1010GI
Torx bit set
Fig. 309
Install
15
Retrofit central interface
module (1)
AZ82.60-P-0004-01A
16
Insert antenna cable for
FM modulator (6) into
vehicle antenna cable (7)
17
Cover connector with
self-adhesive foamed
2001 Mercedes-Benz ML320
1998-2005 ACCESSORIES & BODY, CAB Electrical System - Body - 163 Chassis
me
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст