Mercedes-Benz Sprinter / Dodge Sprinter. Manual — part 442
(17) Install exhaust heat shield (5) (Fig. 76).
(18) Install retaining bracket (4) (Fig. 76). Bracket
is asymmetric. The slanted side must be installed on
the left side in the direction of travel.
(19) Attach propeller shaft (1) (Fig. 76) to the
transmission (Refer to 3 - DIFFERENTIAL & DRIV-
ELINE/PROPELLER SHAFT/PROPELLER SHAFT -
INSTALLATION).
(20) Install oil filler pipe.
(a) Guide oil filler pipe (1) (Fig. 77) down and
into position.
(b) Push lower connection of oil filler pipe (1)
(Fig. 77) into the fill hole in the side of the trans-
mission housing.
(c) Install bolts (2) (Fig. 77) to cylinder head.
Tighten the bolts to 8 N·m (71 in.lbs.).
(d) Install bolt (3) (Fig. 77) to transmission
flange
and
bolt
(2)
to
transmission
housing.
Tighten the bolt to 8 N·m (71 in.lbs.).
Fig. 74 Cable Support
1 - CABLE
2 - BOLT
Fig. 75 Driver’s Side Cooler Line
1 - COOLER LINE
Fig. 76 Propeller Shaft and Heat Shield
1 - PROPELLER SHAFT
2 - BOLT
3 - BOLT
4 - RETAINING BRACKET
5 - HEAT SHIELD
6 - WASHER
7 - BOLT
VA
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
21 - 63
(21) Install the oil drain plug (2) (Fig. 78) with a
new seal into the transmission oil pan. Tighten the
drain plug to 20 N·m (14.5 ft.lbs.).
(22) Lower vehicle and fill transmission with cor-
rect automatic transmission fluid (Refer to 21 -
TRANSMISSION/AUTOMATIC - NAG1/FLUID AND
FILTER - STANDARD PROCEDURE).
(23) Road test the vehicle and verify the repair.
Fig. 77 Fill Tube
1 - FILL TUBE
2 - BOLTS TO CYLINDER HEAD AND TRANSMISSION HOUS-
ING
3 - BOLT TO TRANSMISSION FLANGE
Fig. 78 Oil Drain Plug
1 - SEAL
2 - DRAIN PLUG
21 - 64
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
VA
SCHEMATICS AND DIAGRAMS
HYDRAULIC FLOW IN PARK
VA
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
21 - 65
HYDRAULIC FLOW IN REVERSE - FAILSAFE
21 - 66
AUTOMATIC TRANSMISSION NAG1 - SERVICE INFORMATION
VA
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст