Great Wall Hover. Manual — part 58
Front reducer assembly
front drive shaft assembly
hanger plank
R
oil seal
front vibration damper
bearing
front vibration damper
front reducer
electric clutch assembly
Power plug of electric clutch
circlip
bearing
front vibration damper
oil seal
front vibration damper
hanger plank
L
front drive shaft assembly
front drive axle vent tube connector assembly
circlip
circlip
Pregummed component
N
m: specified trque
circlip
6. Use the wrench to screw off the bolt on the vent tube
bracket, which is used to fix the vent tube connector.
7. Disconnect the connection between the front drive
shaft assembly and steering knuckle front hub
assembly.
a.
Screw off the connecting bolt which is used to fix the front
hub cover; remove the front hub cover.
b.
Use the circlip pliers to remove the circlip from the front drive
shaft and remove the adjusting washer.
c.
Remove the steering knuckle of both sides and separate it
form the front drive shaft assembly.
1. Support the front of the car; remove two front
wheels and the beam under the front reducer
assembly.
2. Drain the lubrication oil in the front reducer
assembly.
3. Remove the flange of front reducer assembly from
the drive shaft
Caution: Make the assembly mark on the flange of
front reducer assembly and drive shaft before discon-
nect them.
4. Disconnect the connector of power wire of electric
clutch
5. Disconnect three rubber connectors on the front
drive axle vent tube connector assembly.
assembly mark
disconnect three connectors in this place
8. Use the jack to support the front reducer assembly
9. Remove the lifting bolt of front drive axle hanger
plank and carriage.
10. Remove the front drive axle assembly
Caution: Do not damage the drive shaft and front drive
shaft jacket
11. Remove the front drive shaft assembly of both sides
from the front drive axle assembly.
12. Use the wrench to remove the bolt and nut which is
used to fix the front reducer housing.
13. Remove the clump weight assembly and clump
weight bracket welded assembly
(Refer to “Disassembly of Front Reducer Assembly”)
electric clutch connector
N
m: specified torque
Replacement of front reducer assembly oil seal
1. Remove the front drive axle assembly
(Refer to “Removal of Front Reducer Assembly”)
2. Remove the left and right front drive shaft assem-
bly from the front drive axle assembly.
3. Remove and replace the lower oil seal according to
the removal and installation procedure of front drive
shaft assembly and install the new side oil seal on
the front drive shaft, then install them in the front
reducer assembly.
(Refer to “Removal and Installation of Front Drive Shaft
Assembly”)
Replacement of oil seal and major semiaxle oil seal of front reducer assembly
major semiaxle oil seal
major semiaxle pressing assembly
circlip
mechanical wheel of separator
Pregummed component
N
m: Specified torque
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст