Mazda CX 7. Manual — part 6
GENERAL INFORMATION
00-00–19
00-00
Wheel balancer (on the vehicle balancer)
1. Jack up all four wheels.
2. Support the wheels (front or rear) on the side to be measured (near the wheels) using a wheel balancer sensor
stand.
3. Support the wheels on the side not to be
measured (near the wheels) using safety stands.
4. Set up the wheel balancer and rotate the wheels
using engine drive to measure the wheel balance.
SST
• Some global SST or equivalent are used as SSTs necessary for vehicle repair. Note that these SSTs are
marked with global SST numbers.
• Note that a global SST number is written together with a corresponding Mazda SST number as shown below.
Example (section **-60)
Example (Except section **-60)
End Of Sie
acxuuw00000330
1: Mazda SST number
2: Global SST number
Crankshaft Damper Remover
1: 49 UN303 009
2: 303-009
acxuuw00000021
—Global SST Number
—Mazda SST Number
(49 UN30 3009)
303—009
acxuuw00000022
GENERAL INFORMATION
00-00–20
INSTALLATION OF RADIO SYSTEM
id000000800300
• If a radio system is installed improperly or if a high-powered type system is used, the CIS and other systems
may be affected. When the vehicle is to be equipped with a radio, observe the following precautions:
— Install the antenna at the farthest point from control modules.
— Install the antenna feeder as far as possible from the control module wiring harnesses.
— Ensure that the antenna and feeder are properly adjusted.
— Do not install a high-powered radio system.
End Of Sie
ELECTRICAL SYSTEM
id000000800400
Electrical Parts
Battery cable
• Before disconnecting connectors or removing
electrical parts, disconnect the negative battery
cable.
Wiring Harness
• To remove the wiring harness from the clip in the
engine room, pry up the hook of the clip using a
flathead screwdriver.
Caution
• Do not remove the wiring harness
protective tape. Otherwise, the wires
could rub against the body, which could
result in water penetration and electrical
shorting.
BATTERY CABLE
acxuuw00000451
acxuuw00000452
NO GOOD
acxuuw00000453
GENERAL INFORMATION
00-00–21
00-00
Connectors
Disconnecting connectors
• When disconnecting a connector, grasp the
connectors, not the wires.
• Connectors can be disconnected by pressing or
pulling the lock lever as shown.
Locking connector
• When locking connectors, listen for a click
indicating they are securely locked.
GOOD
NO GOOD
acxuuw00000454
acxuuw00000455
acxuuw00000456
GENERAL INFORMATION
00-00–22
Inspection
Caution
• To prevent damage to the terminal, wrap a thin wire around the tester probe before inserting into
terminal.
• When a tester is used to inspect for continuity or
measuring voltage, insert the tester probe from
the wiring harness side.
• Inspect the terminals of waterproof connectors
from the connector side since they cannot be
accessed from the wiring harness side.
Terminals
Inspection
• Pull lightly on individual wires to verify that they
are secured in the terminal.
GOOD
NO GOOD
acxuuw00000457
GOOD
NO GOOD
acxuuw00000458
acxuuw00000459
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст