Mazda CX-9 Grand Touring. Manual — part 400

Fig. 19: Identifying Front Cross Member Components & Torque Specifications
Courtesy of MAZDA MOTORS CORP.

TIE-ROD END BALL JOINT REMOVAL NOTE

1. Remove the tie-rod end ball joint locknut.

2. Disconnect the tie-rod end ball joint using the SST.

2008 Mazda CX-9 Grand Touring

2008 SUSPENSION Front Suspension - Mazda CX-9

Microsoft

Sunday, November 15, 2009 10:23:19 AM

Page 13

© 2005 Mitchell Repair Information Company, LLC.

Fig. 20: Disconnecting Tie-Rod End Ball Joint
Courtesy of MAZDA MOTORS CORP.

STEERING GEAR AND LINKAGE, FRONT STABILIZER, FRONT LOWER ARM AND FRONT
CROSSMEMBER COMPONENT REMOVAL NOTE

1. Support the crossmember component with a jack.

Fig. 21: Supporting Crossmember Component With Jack
Courtesy of MAZDA MOTORS CORP.

2. Disconnect the following parts.



Pressure hose eye connector



Return hose clamp (steering gear side)



Pressure hose bracket



Return hose clamp (tank side)

WARNING:



Removing the crossmember component is dangerous. The
crossmember component could fall and cause serious injury or
death. Verify that the jack securely supports the crossmember
component.

2008 Mazda CX-9 Grand Touring

2008 SUSPENSION Front Suspension - Mazda CX-9

Microsoft

Sunday, November 15, 2009 10:23:19 AM

Page 14

© 2005 Mitchell Repair Information Company, LLC.

Fig. 22: Identifying Pressure Hose Eye Connector & Return Hose Clamp
Courtesy of MAZDA MOTORS CORP.

3. Disconnect the oil cooler bracket.

Fig. 23: Identifying Oil Cooler Bracket
Courtesy of MAZDA MOTORS CORP.

4. Remove the No.1 engine mounting bracket bolts.

5. Lower the steering gear and linkage, front stabilizer, front lower arm and front crossmember component

slightly.

2008 Mazda CX-9 Grand Touring

2008 SUSPENSION Front Suspension - Mazda CX-9

Microsoft

Sunday, November 15, 2009 10:23:19 AM

Page 15

© 2005 Mitchell Repair Information Company, LLC.

Fig. 24: Locating No.1 Engine Mounting Bracket Bolts
Courtesy of MAZDA MOTORS CORP.

FRONT CROSSMEMBER MOUNTING RUBBER (FRONT) INSTALLATION NOTE

1. Install so that the smaller end of the outer diameter is pointing up.

Fig. 25: Identifying Front Crossmember Mounting Rubber (Front) Installation
Courtesy of MAZDA MOTORS CORP.

FRONT CROSSMEMBER MOUNTING RUBBER (REAR) INSTALLATION NOTE

1. Install so that the larger end of the outer diameter is pointing up.

Fig. 26: Identifying Front Crossmember Mounting Rubber (Rear) Installation
Courtesy of MAZDA MOTORS CORP.

STEERING GEAR AND LINKAGE, FRONT STABILIZER, FRONT LOWER ARM AND FRONT
CROSSMEMBER COMPONENT INSTALLATION NOTE

2008 Mazda CX-9 Grand Touring

2008 SUSPENSION Front Suspension - Mazda CX-9

Microsoft

Sunday, November 15, 2009 10:23:19 AM

Page 16

© 2005 Mitchell Repair Information Company, LLC.