Mazda Xedos 6. Handbuch — teil 184
Capacities
MAZDA - Xedos 6 - 2.0i V6 24V - KF
Item
Units
Values
Engine sump, incl. filter
4.2
(l)
Manual transmission
Gearbox refill
2.7
(l)
Automatic transmission
Gearbox refill
(l)
6.8
Cooling system
7.5
(l)
Air-conditioner refrigerant
(g)
700
Air-conditioner compressor oil
(ml)
175
© Copyright, Wessels + Mьller AG
General information
Except Xedos 9 2,3
Trouble codes are displayed by using an LED connected to the data link connector (DLC).
Except 323 1998
, 626/Estate/MX-5 1997
: Engine control module (ECM) displays all available diagnostic
information for immobilizer system.
DLC without wiring/terminals in positions FAT & TAT: Engine control module (ECM) incorporates transmission control
function.
DLC with wiring/terminals in positions FAT & TAT: Transmission control module (TCM) mounted separately.
The ECM fault memory can also be checked and erased using diagnostic equipment connected to the data link connector
(DLC).
Xedos 9 2,3
Trouble codes are displayed by using an LED connected to the data link connector (DLC).
Engine control module (ECM) displays all available diagnostic information for immobilizer system.
Transmission control module (TCM) mounted separately.
Data bus connecting ECM to TCM allows faults relating to both systems to be displayed when accessing ECM fault
memory.
The ECM/TCM fault memory can also be checked and erased using diagnostic equipment connected to the data link
connector (DLC).
Accessing
Ensure ignition switched OFF.
Bridge data link connector (DLC) terminals GND and TEN
Fig. 1
.
Connect LED test lamp between terminals FEN and B+
Fig. 1
.
NOTE: Connect LED test lamp positive connection to DLC terminal B+.
Switch ignition ON.
Count LED flashes. Note trouble codes. Compare with trouble code table.
Two digit trouble codes are displayed as follows:
Long flashes indicate the 'tens'
Fig. 2
[A].
Short flashes indicate the 'units'
Fig. 2
[C].
For example: Trouble code 12 displayed
Fig. 2
.
Four digit trouble codes are displayed as follows:
Each trouble code consists of four groups.
A long flash indicates the start of each group
Fig. 3
[A].
Short flashes indicate the digits of each group
Fig. 3
[B].
No short flashes in a group indicate '0'.
For example: Trouble code 0120 displayed
Fig. 3
.
Switch ignition OFF. Rectify faults as necessary.
Erasing
Ensure ignition switched OFF.
Disconnect battery earth lead for at least 30 seconds.
Depress brake pedal for at least 20 seconds.
Reconnect battery earth lead.
Repeat checking procedure to ensure no data remains in ECM fault memory.
WARNING: Disconnecting the battery may erase memory from electronic units (e.g. radio, clock).
Trouble code identification
Flash type
Manufacturer: Mazda
Model: Xedos 6 (CA) 2,0
Engine code: KF
Output: 103 (140) 6000
Tuned for: R-Cat
Year: 1995-00
© Autodata Limited 2004
26.03.2007
V5.500-
Flash type
2-digit
Fault location
Probable cause
01
Ignition pulse missing
Wiring, tachometer, ignition coil, distributor, ECM, TCM
02
Diesel: Engine speed (RPM) sensor - no signal
Wiring, RPM sensor
02
1
Petrol: Crankshaft position (CKP) sensor/engine
speed (RPM) sensor - no signal
Wiring, sensor supply voltage, CKP/RPM sensor
03
Camshaft position (CMP) sensor - no signal
Wiring, sensor supply voltage, CMP sensor
04
Diesel: Crankshaft position (CKP) sensor - no signal
Wiring, sensor supply voltage, CKP sensor
04
2
Petrol: Crankshaft position (CKP) sensor/engine
speed (RPM) sensor - no signal
Wiring, sensor supply voltage, CKP/RPM sensor
05
Knock sensor (KS)
Wiring, KS
06
Vehicle speed sensor (VSS)
Wiring, speedometer, VSS
08
Mass air flow (MAF) sensor/volume air flow (VAF)
sensor
Wiring, MAF/VAF sensor
09
Engine coolant temperature (ECT) sensor
Wiring, ECT sensor
10
Intake air temperature (IAT) sensor
Wiring, IAT sensor
11
Intake air temperature (IAT) sensor
Wiring, IAT sensor
12
Throttle position (TP) sensor
Wiring, TP sensor adjustment, TP sensor
14
Barometric pressure (BARO) sensor
Wiring, BARO sensor, ECM
15
Except V6: Oxygen sensor (O2S)/heated oxygen
sensor (HO2S) - no activity
Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs
15
V6: Heated oxygen sensor (HO2S), bank 2 - no
activity
Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs
16
Exhaust gas recirculation (EGR) valve position
sensor
Wiring, EGR valve position sensor
17
Except V6: Oxygen sensor (O2S)/heated oxygen
sensor (HO2S) - incorrect signal
Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs
17
V6: Heated oxygen sensor (HO2S), bank 2 -
incorrect signal
Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs
18
Fuel quantity adjuster
Wiring, fuel quantity adjuster/position sensor
19
Fuel quantity adjuster position sensor
Wiring, fuel quantity adjuster position sensor
22
Fuel shut-off solenoid
Wiring, fuel shut-off solenoid
23
Diesel: Fuel temperature sensor
Wiring, fuel temperature sensor
23
Petrol: Heated oxygen sensor (HO2S), bank 1 - no
activity
Intake leak, wiring, O2S/HO2S, injector(s), ECT sensor,
MAF sensor, spark plugs
24
Heated oxygen sensor (HO2S), bank 1 - incorrect
signal
Intake leak, fuel pressure/pump, wiring, O2S/HO2S,
injector(s), ECT sensor, MAF sensor, spark plugs
25
Fuel pressure regulator control solenoid
Wiring, fuel pressure regulator control solenoid
26
Evaporative emission (EVAP) canister purge valve
Wiring, EVAP canister purge valve
28
Exhaust gas recirculation (EGR) solenoid - vacuum
Wiring, EGR solenoid
29
Exhaust gas recirculation (EGR) solenoid - vent
Wiring, EGR solenoid
34
Idle air control (IAC) valve
Wiring, IAC valve
35
Fuel pressure regulator control solenoid 2
Wiring, fuel pressure regulator control solenoid
36
Glow plug relay
Wiring, glow plug relay
41
Intake manifold air control solenoid 1
Wiring, intake manifold air control solenoid
43
Fuel injection timing sensor
Wiring, fuel injection timing sensor/solenoid
46
Petrol: Intake manifold air control solenoid 2
Wiring, intake manifold air control solenoid
46
Diesel: Closed throttle position (CTP) switch
Wiring, CTP switch
49
Engine control module (ECM) - defective
ECM
52
Module coding plug
Wiring, module coding plug
Manufacturer: Mazda
Model: Xedos 6 (CA) 2,0
Engine code: KF
Output: 103 (140) 6000
Tuned for: R-Cat
Year: 1995-00
© Autodata Limited 2004
26.03.2007
V5.500-
55
Input shaft speed (ISS) sensor/turbine shaft speed
(TSS) sensor
Wiring, ISS/TSS sensor
56
323: Engine control module (ECM) - supply voltage
Wiring, ECM
56
626: Transmission fluid temperature (TFT) sensor
Wiring, TFT sensor
57
Engine control relay
Wiring, engine control relay
60
Shift solenoid (SS) A, 1-2
Wiring, SS
61
Shift solenoid (SS) B, 2-3
Wiring, SS
62
Shift solenoid (SS) C, 3-4
Wiring, SS
63
Torque converter clutch (TCC) control solenoid
Wiring, TCC control solenoid
64
Shift timing solenoid, 3-2
Wiring, shift timing solenoid
65
Torque converter clutch (TCC) solenoid
Wiring, TCC solenoid
66
Transmission fluid pressure (TFP) solenoid
Wiring, TFP solenoid
67
Engine coolant blower motor relay - low temperature Wiring, engine coolant blower motor relay
68
Engine coolant blower motor relay - high temperature Wiring, engine coolant blower motor relay
69
Engine coolant blower motor temperature sensor
Wiring, engine coolant blower motor temperature sensor
71
Engine control module (ECM)/immobilizer control
module - communication error
Wiring, immobilizer control module, ECM
72
Ignition key - not programmed into ECM
ECM incorrectly programmed/not programmed
73
Engine control module (ECM)/immobilizer control
module - immobilizer codes do not match
Incorrectly programmed immobilizer control module/ECM
74
Engine control module (ECM)/immobilizer control
module - ignition key codes not match
Incorrect/damaged key, ECM incorrectly programmed
75
Engine control module (ECM) - EEPROM error
ECM
76
Engine control module (ECM) - immobilizer code not
stored
ECM incorrectly/not programmed
77
Immobilizer control module - communication error
Incorrect/damaged key, wiring, reader coil, immobilizer
control module
P type 4-
digit
Fault location
Probable cause
P0
Refer to EOBD trouble code table
-
P1100
Mass air flow (MAF) sensor - circuit intermittent
Wiring, MAF sensor
P1101
Mass air flow (MAF) sensor - circuit intermittent
Wiring, MAF sensor
P1110
Intake air temperature (IAT) sensor 2
Wiring, IAT sensor
P1112
Intake air temperature (IAT) sensor - circuit
intermittent
Wiring, IAT sensor
P1113
Intake air temperature (IAT) sensor 2
Wiring, IAT sensor
P1117
Engine coolant temperature (ECT) sensor - circuit
intermittent
Wiring, ECT sensor
P1120
Throttle position (TP) sensor - low input
Wiring short to earth, TP sensor
P1125
Throttle position (TP) sensor - circuit intermittent
Wiring, TP sensor
P1130
Fuel trim (FT) - control limit exceeded
Intake/exhaust leak, fuel pressure/pump, EVAP/EGR system,
wiring, HO2S
P1131
Heated oxygen sensor (HO2S) - low voltage
Intake/exhaust leak, fuel pressure low, hose connection,
HO2S/wiring short to earth, injector(s), MAF sensor/wiring
P1132
Heated oxygen sensor (HO2S) - high voltage
Intake/exhaust blockage, fuel pressure high, EVAP/EGR
system, HO2S/wiring short to positive, injector(s), MAF sensor
P1170
Oxygen sensor (O2S)/heated oxygen sensor
(HO2S), bank 1 - incorrect signal
Intake leak, fuel pressure/pump, wiring, O2S/HO2S, injector(s),
ECT sensor, MAF sensor, spark plugs
P1173
Oxygen sensor (O2S)/heated oxygen sensor
(HO2S), bank 2 - incorrect signal
Intake leak, fuel pressure/pump, wiring, O2S/HO2S, injector(s),
ECT sensor, MAF sensor, spark plugs
Manufacturer: Mazda
Model: Xedos 6 (CA) 2,0
Engine code: KF
Output: 103 (140) 6000
Tuned for: R-Cat
Year: 1995-00
© Autodata Limited 2004
26.03.2007
V5.500-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст