Mazda Training manual — part 201
![](/vehicles/rke/hty/ntwithamb/akem.png)
TC001-18-01H
INTRODUCTION TO M-MDS
07 - Reprogramming/Updating a PCM
Activity 07- Page 9
Activity 07
(Continued)
22. Tap
tick.
23. This screen flashes on then off.
24. The vehicle you are working on may or may not
have DTCs. Some DTCs must be addressed
before PCM reprogramming. If you are not sure
whether the DTC(s) needs to be addressed
before reprogramming, ask your instructor
![](/vehicles/rke/hty/ntwithamb/cheromy.png)
TC001-18-01H
INTRODUCTION TO M-MDS
07 - Reprogramming/Updating a PCM
Activity 07- Page 10
Activity 07
(Continued)
25. Tap
tick.
26. Turn the ignition key OFF,
then tap tick.
27. Make sure a battery charger is
attached to the vehicle and set it to
around 15 amps.
Do not remove fuses as instructed.
Tap
tick.
![](/vehicles/rke/hty/ntwithamb/yslie.png)
TC001-18-01H
INTRODUCTION TO M-MDS
07 - Reprogramming/Updating a PCM
Activity 07- Page 11
Activity 07
(Continued)
28. Turn the ignition key ON.
29. This screen flashes
on then off.
30. The blue “status bar” indicates the
progress of data being downloaded
to the PDS. It will take several
minutes to complete this process.
![](/vehicles/rke/hty/ntwithamb/utrucri.png)
TC001-18-01H
INTRODUCTION TO M-MDS
07 - Reprogramming/Updating a PCM
Activity 07- Page 12
Activity 07
(Continued)
31. Turn the ignition key OFF, then
tap tick.
32. This screen indicates the
progress of the module
programming. It will take about
15 seconds.
33. Turn the ignition key ON, then
tap tick.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст