Mazda Protege 5. Manual — part 161
CRUISE CONTROL SYSTEM
01–20–5
01–20
ACTUATOR CABLE REMOVAL
A3U012066311W01
1. Loosen the nut, and remove the actuator cable.
2. Press the tabs of the bush, and remove it from the
accelerator pedal.
3. Press the tabs of the grommet, and remove it
from the dash lower panel.
4. Push the actuator cable through the dash lower
panel to remove it.
End Of Sie
ACTUATOR CABLE INSTALLATION
A3U012066311W02
1. Install the grommet to the dash lower panel.
Z3U0120W004
Y3U120WA5
Y3U120WA6
Y3U120WA6
1712-1U-01G(01-20).fm 5 ページ 2001年6月29日 金曜日 午前9時49分
CRUISE CONTROL SYSTEM
01–20–6
2. Install the actuator cable to the accelerator pedal.
3. Slide the lock lever in the direction shown by the
arrow to unlock the adjuster.
4. Turn the ratchet ring to release lock in the
direction shown by the arrow.
5. Insert the grommet into the actuator bracket.
6. To adjust the free play, push or pull the actuator
cable directly behind the spring two times.
Y3U120WA5
YMU120WAA
YMU120WAB
Z3U0120W004
YMU120WAJ
1712-1U-01G(01-20).fm 6 ページ 2001年6月29日 金曜日 午前9時49分
CRUISE CONTROL SYSTEM
01–20–7
01–20
7. Turn the ratchet ring in the direction shown by the
arrow to lock it.
8. Slide the lock lever in the direction shown by the
arrow to lock the adjuster.
End Of Sie
CRUISE CONTROL SWITCH REMOVAL/INSTALLATION
A3U012066341W01
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See 08–10–5 DRIVER-SIDE AIR BAG MODULE REMOVAL/
INSTALLATION.)
3. Disconnect the cruise control switch connector.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
End Of Sie
YMU120WAC
YMU120WAD
1
Screw (4SD)
2
Horn button contact (4SD)
3
Screw
4
Cruise control switch
A3U0120W102
1712-1U-01G(01-20).fm 7 ページ 2001年6月29日 金曜日 午前9時49分
CRUISE CONTROL SYSTEM
01–20–8
CRUISE CONTROL SWITCH INSPECTION
A3U012066341W02
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See 08–10–5 DRIVER-SIDE AIR BAG MODULE REMOVAL/
INSTALLATION.)
3. Disconnect the cruise control switch connector.
4. Measure the resistance and inspect for continuity
between the cruise control switch terminals using
an ohmmeter.
End Of Sie
Y3U120WA4
Z3U0120W005
1712-1U-01G(01-20).fm 8 ページ 2001年6月29日 金曜日 午前9時49分
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст