Mazda MX-5 Miata / Grand Touring. Manual — part 92
EVAP system leak detection pump terminal A and main relay
EVAP system leak detection pump terminal B and body ground
Short Circuit
If there is continuity, there is a short circuit. Repair or replace the wiring harness.
EVAP system leak detection pump terminal C and body ground
EVAP system leak detection pump terminal D and body ground
EVAP system leak detection pump terminal C and power supply
EVAP system leak detection pump terminal D and power supply
EVAP system leak detection pump terminal A and body ground
EVAP system leak detection pump terminal B and power supply
2008 Mazda MX-5 Miata Grand Touring
2008 ENGINE PERFORMANCE Emission System - MX-5 Miata
Fig. 18: Identifying PCM Wiring Harness-Side Connector
Courtesy of MAZDA MOTORS CORP.
PURGE SOLENOID VALVE REMOVAL/INSTALLATION [LF]
1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
3. Disconnect the purge solenoid valve connector.
4. Disconnect the vacuum hose from the purge solenoid valve.
5. Remove the purge solenoid valve from the air hose.
2008 Mazda MX-5 Miata Grand Touring
2008 ENGINE PERFORMANCE Emission System - MX-5 Miata
Fig. 19: View Of Purge Solenoid Valve & Air Hose
Courtesy of MAZDA MOTORS CORP.
6. Install in the reverse order of removal.
PURGE SOLENOID VALVE INSPECTION [LF]
AIRFLOW INSPECTION
1. Remove the purge solenoid valve without disconnecting the evaporative hose. (See PURGE
SOLENOID VALVE REMOVAL/INSTALLATION [LF] ).
2. Verify that the airflow is as indicated in PURGE SOLENOID VALVE AIRFLOW REFERENCE
TABLE .
If as specified in PURGE SOLENOID VALVE AIRFLOW REFERENCE TABLE , perform
the CIRCUIT OPEN/SHORT INSPECTION .
If not as specified in PURGE SOLENOID VALVE AIRFLOW REFERENCE TABLE , inspect
the purge solenoid valve. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION
[LF] .)
PURGE SOLENOID VALVE AIRFLOW REFERENCE TABLE
NOTE:
Perform the following procedure only when directed.
2008 Mazda MX-5 Miata Grand Touring
2008 ENGINE PERFORMANCE Emission System - MX-5 Miata
Fig. 20: Inspecting Airflow
Courtesy of MAZDA MOTORS CORP.
CIRCUIT OPEN/SHORT INSPECTION
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [LF] .)
2. Inspect the following wiring harnesses for open or short circuit (continuity check).
Measured condition
Continuity between A-B
When voltage is not applied between terminals A
and B
No airflow
When voltage is applied between terminals A
and B
Airflow detected
2008 Mazda MX-5 Miata Grand Touring
2008 ENGINE PERFORMANCE Emission System - MX-5 Miata
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст