Mazda MX-5 Miata / Grand Touring. Manual — part 126
Not using M-MDS
1. Short the check connector terminal F/P to ground using a jumper wire.
Fig. 50: Checking Connector Terminal F/P To Ground Using Jumper Wire
Courtesy of MAZDA MOTORS CORP.
2008 Mazda MX-5 Miata Grand Touring
2008 ENGINE Fuel System - MX-5 Miata
Fig. 51: Identifying F/P Connector Terminal
Courtesy of MAZDA MOTORS CORP.
2. Turn the ignition switch to the ON position to operate the fuel pump.
7. Measure the injection volume of each fuel injector.
If not within the specification, replace the fuel injector. (See FUEL INJECTOR
REMOVAL/INSTALLATION [LF] .)
Fuel injection volume
204-216 ml {204-216 cc, 12.5-13.1 cu in}/min
8. Turn the ignition switch to off to stop the fuel pump.
9. Install the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION [LF] .)
10. Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION [LF] .)
ATOMIZATION INSPECTION
1. Inspect the atomization status.
If not normal, replace the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION
2008 Mazda MX-5 Miata Grand Touring
2008 ENGINE Fuel System - MX-5 Miata
[LF] .)
Fig. 52: Inspecting Atomization Status
Courtesy of MAZDA MOTORS CORP.
2008 Mazda MX-5 Miata Grand Touring
2008 ENGINE Fuel System - MX-5 Miata
2008 HVAC
Basic System - MX-5 Miata
HVAC BASIC SYSTEM
Fig. 1: Identifying Location Of HVAC Basic System Components
Courtesy of MAZDA MOTORS CORP.
AIR DISTRIBUTION UNIT REMOVAL/INSTALLATION
1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] )
3. Discharge the refrigerant from the system. (See REFRIGERANT RECOVERY .) (See
REFRIGERANT CHARGING .)
4. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [LF] .)
2008 Mazda MX-5 Miata Grand Touring
2008 HVAC Basic System - MX-5 Miata
2008 Mazda MX-5 Miata Grand Touring
2008 HVAC Basic System - MX-5 Miata
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст