Mazda 5. Manual — part 32
05–17–48
AUTOMATIC TRANSAXLE
34. Remove the pawl return spring.
35. Remove the end cover.
36. Remove the O-ring from the transaxle case.
37. Remove the band strut.
38. Remove the 2–4 brake band, and hold it together
using a piece of wire as shown in the figure.
39. Remove the clutch component.
PAWL RETURN SPRING
B3E0517A220
O-RING
O-RING
END COVER
B3E0517A221
BAND STRUT
B3E0517A222
B3E0517A223
B3E0517A224
AUTOMATIC TRANSAXLE
05–17–49
05
40. Remove the snap ring.
41. Remove the rear planetary gear component.
42. Remove the front sun gear by tapping its end with
a flathead screwdriver or similar tool. as shown in
the figure.
43. Remove the forward clutch hub.
44. Remove the front planetary gear component.
45. Remove the front internal gear and one-way
clutch component.
46. Remove the locknut.
B3E0517A225
B3E0517A226
FRONT SUN GEAR
FORWARD CLUTCH HUB
B3E0517A227
FRONT PLANETARY
GEAR COMPONENT
BEARING
B3E0517A228
B3E0517A229
05–17–50
AUTOMATIC TRANSAXLE
(1) Knock the crimped portion of the locknut
outward by using a small chisel and a
hammer.
(2) Install the SST to the primary gear in the
order shown.
Tightening torque
19—25 N·m {1.9—2.6 kgf·m, 14—18 ft·lbf}
(3) Install the SST to the locknut in the order
shown.
(4) Remove the locknut.
47. Remove the primary gear by tapping it with a
flathead screwdriver, etc. as shown in the figure.
LOCKNUT
B3E0517A230
49 B019 019
49 B019 020
1
2
CONVERTER HOUSING SIDE
B3E0517A231
49 B019 021
49 B019 022
2
3
1
EXTENSION BAR
END COVER SIDE
B3E0517A232
B3E0517A233
PRIMARYGEAR
B3E0517A234
AUTOMATIC TRANSAXLE
05–17–51
05
48. Remove the bearing and distance piece.
Caution
• Removing the bearing race using a
flathead screwdriver can damage the
inside of the bearing race. Handle the
flathead screwdriver carefully.
49. Remove torx screws from the converter housing
side.
50. Remove the bearing race.
51. Remove the bearing race using the SST as
shown in the figure.
52. Tap the funnel at the areas indicated in the figure
using a flathead screwdriver, etc. to make gaps
big enough to install the SST. Then remove the
bearing race.
53. Remove the funnel.
Caution
• Removing the oil pipe using a flathead
screwdriver can damage the oil pipe.
Handle the flathead screwdriver carefully.
54. Remove the oil pipe.
End Of Sie
BEARING
DISTANCE
PIECE
B3E0517A235
TORX
SCREW
BEARING
RACE
B3E0517A334
49 W032 2A0
B3E0517A238
49 W032 2A0
BEARING RACE
FUNNEL
B3E0517A239
B3E0517A240
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст