Loader Bobcat 853, 853H. Manual — part 52
STARTER (Cont’d)
Disassembly And Assembly (Cont’d)
Remove the armature and brushes from the starter
housing [A].
Remove the bolts from the reduction gear housing [B].
Remove the reduction gear housing [C].
A
CD–08928
C
CD–08930
–6–20–
853, 853H Loader
Service Manual
B
CD–08929
STARTER (Cont’d)
Cleaning And Inspection
Use a brush and air pressure to clean the drive, field coils,
armature and starter housing.
NOTE: DO NOT use solvent to clean the drive
assembly. The solvent will remove the
lubricant and the drive will slip.
Check the following items:
Armature
Broken or burned insulation
Loose connections at commutator
Open or grounded circuits [A] & [B]
Worn shaft or bearings
Rough commutator
Brush Holders
Broken springs
Broken insulation
Spring tension
Field Coils
Broken or burned insulation
Electrical continuity
Brush connections
Drive Gears
Worn teeth
Tooth engagement
A
A–01995
853, 853H Loader
–6–21–
Service Manual
B
A–01994
STANDARD INSTRUMENT PANEL
Removal And Installation
Pry the rubber light mount loose from the operator cab
(both sides) [A].
Lower the light from the operator cab and locate the three
instrument panel mounting bolts (Item 1) [B] (both sides).
Remove the three mounting bolts (Item 1) [B].
Installation: Be careful not to overtighten the instrument
panel mounting bolts to prevent stripping the threaded
holes in the panels.
Pull the left instrument panel down and disconnect the
wire harness connectors from the panel. Remove the
panel [C].
Repeat steps [A] and [B]. Pull the right instrument panel
down and disconnect the wire harness connectors from
the panel. Remove the panel [D].
Reverse the removal procedure to install the instrument
panel.
A
P–03995
C
P–00962
D
P–00964
–6–22–
853, 853H Loader
Service Manual
B
P–03955
1
1
FRONT LIGHTS
Removal And Installation
The front lights are mounted in the upper corners of the
operator cab [A].
Pry the rubber light mount free from the operator cab [B].
Pull the light down and remove the three mounting bolts
(Item 1) [C] from the instrument panel.
Disconnect the front light connector from the instrument
panel. Remove the front light from the operator cab.
Reverse the removal procedure to install the front light.
A
P–03956
C
P–03955
1
1
853, 853H Loader
–6–23–
Service Manual
963 Service Manual #6724545–Electrical System Section Part 2 of 2
B
P–03995
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст