Loader Bobcat 773. Manual — part 76
STARTER (DENSO) (Cont’d)
Disassembly
Remove the cable (Item 1) [A] from the magnetic switch.
Remove the bolts (Item 1) [B].
Remove the frame (Item 1) [C] from the magnetic switch.
Remove the bolts (Item 1) [D] from the brush cover (Item
2) [D].
Remove the cover (Item 2) [D].
A
N–15158
1
C
N–15160
1
D
N–15161
1
1
2
–6–20–
773 BICS Loader
Service Manual
B
N–15159
1
1
STARTER (DENSO) (Cont’d)
Disassembly (Cont’d)
Using a needle nose pliers, pull the brush springs (Item
1) [A] back and remove the brushes (Item 2) [A].
NOTE: The brushes are non–replaceable. If the
brushes are worn order a new brush holder
(for the negative brushes) and yolk (for the
positive brushes).
Remove the brush holder (Item 3) [A] from the end of the
armature.
Remove the armature (Item 1) [B] from the frame.
Remove the bearings (Item 2) [B] from both ends of the
armature.
Remove the bolts (Item 1) [C] from the starter housing.
Remove the starter housing (Item 1) [D] from the
magnetic switch.
A
N–00980
2
1
3
C
N–15162
1
1
1
D
N–15163
1
773 BICS Loader
–6–21–
Service Manual
B
N–00981
1
2
2
STARTER (DENSO) (Cont’d)
Disassembly (Cont’d)
Remove the ball (Item 1) [A] from the pinion shaft.
Tap the starter pinion/clutch assembly (Item 1) [B] out of
the starter housing.
Remove the O–ring (Item 1) [C].
Press down on the pinion (Item 1) [D] and retainer (Item
2) [D].
A
N–15164
1
C
N–15166
1
D
N–00987
2
1
–6–22–
773 BICS Loader
Service Manual
B
N–15165
1
STARTER (DENSO) (Cont’d)
Disassembly (Cont’d)
Remove the snap ring (Item 1) [A].
Remove the retainer (Item 1) [B] and pinion (Item 2) [B].
Remove the spring seat (Item 3) [B] and spring (Item 4)
[B].
Remove the pinion shaft (Item 1) [C] and spring (Item 2)
[C] from the over running clutch (Item 3) [C].
Remove the spring (Item 1) [D] from the magnetic switch
housing.
A
N–15011
1
C
N–00989
1
2
3
D
N–15167
1
773 BICS Loader
–6–23–
Service Manual
B
N–00988
1
3
2
4
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст