Acura RL (1996-2004 year). Manual — part 714
Check for a short to power between the right side wire har-
ness and the SRS floor harness (4):
1. Turn the ignition switch OFF.
2. Disconnect the left side wire harness 2P connector (see
).
3. Turn the ignition switch ON (II).
4. Check for voltage between the No. 10 terminal of the
SRS floor harness 18P connector and body ground.
There should be 0.5 V or less.
Faulty side airbag indicator light circuit; go to troubleshoot-
ing 15-2.
Check for a short to power between the right side wire har-
ness and the SRS floor harness (3):
1. Turn the ignition switch OFF.
2. Disconnect the main wire harness 14P connector (see
).
3. Turn the ignition switch ON (II).
4. Check for voltage between the No. 10 terminal of the
SRS floor harness 18P connector and body ground.
There should be 0.5 V or less.
Check the OPDS sensor:
1. Turn the ignition switch OFF.
2. Install a known-good OPDS sensor.
3. Reinstall all removed parts.
4. Initialize the OPDS sensor.
5. Erase the DTC memory (see page
).
).
From page
(L) (K) From page
Main Menu
Table of Contents
Check for an open between the right side wire harness and
the SRS floor harness (3):
1. Disconnect the left side wire harness HP connector (see
page
24-93
).
2. Check resistance between the No. 10 terminal of the SRS
floor harness 18P connector and the No. 14 terminal of
the left side wire harness 14P connector.
There should be 0- 1.0
Check for an open between the right side wire harness and
the SRS floor harness (4):
1. Disconnect the SRS floor harness 2P connector (see page
).
2. Check resistance between the No. 10 terminal of the SRS
floor harness 18P connector and the No. 2 terminal of the
SRS floor harness 2P connector.
There should be 0- 1.0
(J)
DTC 15-1 (cont'd)
Troubleshooting - '99 - 01 Models
Main Menu
Table of Contents
DTC 15-2
CAUTION: Whenever the ignition switch is ON (II), or has
been turned OFF for less than 3 minutes, be careful not
to bump the SRS unit or the side impact sensor; the
airbags could accidentally deploy and cause damage or
injuries.
Check the fuse:
1. Turn the ignition switch OFF.
2. Check the No. 13 (7.5 A) fuse in the under-dash fuse/relay
).
(C) To page
To page
(D)
Check for an open in the side airbag indicator circuit:
1. Disconnect the OPDS unit wire harness 8P connector
).
2. Turn the ignition switch ON (II).
3. Check for voltage between the No. 3 terminal of the
OPDS unit wire harness 8P connector and body ground.
There should be battery voltage.
Main Menu
Table of Contents
Troubleshooting - '99 - 01 Models
DTC 15-2 (cont'd)
(C) From page
Check for a short to power in the side airbag indicator cir-
cuit:
1. Turn the ignition switch OFF.
2. Disconnect the left engine compartment wire harness
16P connector from the under-dash fuse/relay box (see
).
3. Turn the ignition switch ON (II).
4. Check for voltage between the No. 3 terminal of the
OPDS unit wire harness 8P connector and body ground.
There should be 0.5 V or less.
Check for a short to power between the main wire harness
and the right side wire harness (2):
1. Turn the ignition switch OFF.
2. Disconnect the dashboard wire harness 8P connector
from the main wire harness (see page
).
3. Turn the ignition switch ON (II).
4. Check for voltage between the No. 3 terminal of the
OPDS unit wire harness 8P connector and body ground.
There should be 0.5 V or less.
Check for a short to power in the right side wire harness (3):
1. Turn the ignition switch OFF.
2. Disconnect the right side wire harness 24P connector
(see page
).
3. Turn the ignition switch ON (II).
4. Check for voltage between the No. 3 terminal of the
OPDS unit wire harness 8P connector and body ground.
Check for a short to power between the dashboard wire
harness and the right side wire harness (1):
1. Turn the ignition switch OFF.
2. Disconnect the dashboard wire harness 22P connector
from the gauge assembly (see page
).
3. Turn the ignition switch ON (II).
4. Check for voltage between the No. 3 terminal of the
OPDS unit wire harness 8P connector and body ground.
There should be 0.5 V or less.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст