Acura RL (1996-2004 year). Manual — part 474
Intermediate Shaft
Reassembly (cont'd)
1. Press the intermediate shaft inner seal into the
bearing support using the special tools and a press
as shown.
Press
HANDLE DRIVER
BEARING
SUPPORT
DRIVER
ATTACHMENT,
52 x 55 mm
INNER SEAL
2. Press the intermediate shaft bearing into the bear-
ing support using the special tool and a press as
shown.
OIL SEAL DRIVER
or
Press
BEARING
SUPPORT
INTERMEDIATE
SHAFT BEARING
3. Seat the internal snap ring into the groove of the
bearing support.
BEARING SUPPORT
INTERNAL SNAP RING
4. Press the intermediate shaft into the shaft bearing
using the special tool and a press as shown.
Press
INTERMEDIATE SHAFT
INTERMEDIATE
SHAFT BEARING
DRIVER, 40 mm I.D.
Main Menu
Table of Contents
5. Seat the external snap ring into the groove of the
intermediate shaft.
INTERMEDIATE SHAFT
EXTERNAL
SNAP RING
6. Press the outer seal into the bearing support using
the special tools and a press as shown.
NOTE: Drive in the outer seal until it is 7.0 mm
(0.28 in) from the end of the bearing support.
DRIVER
ATTACHMENT
Press
HANDLE DRIVER
OUTER SEAL
O-RING
7. Install the new O-ring into the bearing support
groove.
8. Install the new set ring into the intermediate shaft
groove.
7.0
±
0.2 mm
(0.28 ± 0.01 in)
Main Menu
Table of Contents
Installation
1. Insert the intermediate shaft into the differential
with "LOWER" mark facing down.
NOTE: Clean the areas where the intermediate shaft
contacts the differential thoroughly with solvent or
carburetor cleaner, and dry with compressed air.
INTERMEDIATE SHAFT
MARK
2. Install the three flange bolts, then tighten them.
FLANGE BOLT
8 x 1.25 mm
22 N-m (2.2 kgf-m, 16lbf-ft)
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст