Acura RL (1996-2004 year). Manual — part 24
Rust-preventive Treatments
Areas to be Covered by Anti-rust Agents (cont'd)
Front Wheelhouse
• Spray agent on the wheelhouse, front fender stay,
upper member and damper bracket as shown.
• Undercoat the wheelhouse where anti-rust agent or
undercoat has not yet been applied.
NOTE:
• Coat the damper housing extension, particularly the
upper face.
• Undercoat the inner fender mounting area of the
wheelhouse and upper face of the inner fender
Nozzles used: A and C
Side Sill, Inside
• Remove the rear grommet and side sill panel to spray
agent.
• Insert the nozzle all the way through the grommet holes
and spray.
Move the nozzle right and left, and up and down while
pulling it back out of the grommet hole.
NOTE: Make sure that the nozzle is not interfering with the
side sill bulkheads as shown.
NOTE: Spray agent until it drips from the drain hole.
Nozzles used: A and B
Rear Wheelhouse
• Coat the gaps between the inner and outer
wheelhouses, including the damper base.
• Apply agent to the edge of the rear side frame, side sill
and rear floor.
• Undercoat the wheelhouse where undercoat or
anti-rust agent has not yet been applied.
Nozzles used: B and C
Main Menu
Table of Contents
Under-Floor Member/Floor Frame, Inside
• To spray agent to the inside of the under-floor member,
insert the nozzle in the holes in the members.
• Also coat the under-floor, side sill, and front and rear
wheelhouses at the ends.
Nozzle used: A
Suspension
NOTE:Do not apply to the brake disc and brake caliper.
Coat the outside (and inside if necessary)
• Front Beam • Rear Cross Beam
• Rear Beam • Lower Arm
• Beam Bracket • Radius Rod
• Beam Bridge • Stabilizer
• Damper • Brake Pipe
• Upper Arm
• Steering Knuckle
Under-Floor
• Apply the agent to the shaded areas only. Do not apply it
to the exhaust system and heated oxygen sensors.
• Coat the bottom of the fuel tank.
Nozzle used: C
Main Menu
Table of Contents
Rust-preventive Treatments
Undercoating Diagram
NOTE:
• Coating thickness: 0.5 mm (0.02 in) MIN.
• Follow the above instructions for paint repair or
refinishing.
• Avoid coating on the front and rear suspensions,
and exhaust system mount area.
• Items marked with an asterisk (*) on the important
control areas. Coating thickness 1 mm (0.04 in).
Unit: mm (in)
indicates PVC coating areas.
Coating portion
Coating area
Dashboard lower
Lower section from 250mm(9.84 in) and
entire wheelhouse side.
Entire.
Front floor
Rear floor
Whole floor except fuel tank mounting
area.
Except inner fender mounting area and
damper housing.
Front wheelhouse
Rear wheelhouse
Rear wheelarch
Outer panel
Jack-up bracket
Whole wheelhouse.
Whole wheelhouse.
Between rear wheelhouse and rear
panel.
Bracket flange.
Main Menu
Table of Contents
Color Chart Painting Specifications
NOTE:
• Apply NH-86 black (Gloss 40) to the visible surfaces of
area, front and rear-wheelhouses after installing
equipment(except cars painted with NH-592P, YR-
511P, G-79P and RP-25P
• With body colors are NH-585P, G-83P and YR-508M,
apply NH-86 black (Gloss 40) to the area, front and
rear wheelhouses.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст