Acura RL (1996-2004 year). Manual — part 444
Valve
Assembly
NOTE: Coat all parts with ATP before assembly.
• Install the valve, valve spring and cap in the valve
body, and secure with the roller.
ROLLER
SPRING
VALVE BODY
VALVE
CAP
CAP
SPRING
• Set the spring in the valve, then install them in the
valve body. Push the spring in with a screwdriver,
then install the spring seat.
SPRING SEAT
SPRING
VALVE BODY
• Install the valve, valve spring and cap in the valve
body, then secure with the valve cap clip. Rotate the
valve cap clip until it stops against the valve body
wall.
VALVE CAP
CLIP
VALVE CAP
ROLLER
VALVE BODY
VALVE
Main Menu
Table of Contents
Valve Caps
Description
• Caps with one projected tip and one flat end are
installed with the flat end toward the inside of the
valve body.
• Caps with a projected tip on each end are installed
with the smaller tip toward the inside of the valve
body. The small tip is a spring guide.
TOWARD OUTSIDE OF VALVE BODY
TOWARD INSIDE OF VALVE BODY
• Caps with one projected tip and a hollow end are
installed with the tip toward the inside of the valve
body. The tip is a spring guide.
TOWARD OUTSIDE OF VALVE BODY
TOWARD INSIDE OF VALVE BODY
• Caps with hollow ends are installed with the hollow
end away from the inside of the valve body.
• Caps with notched ends are installed with the notch
toward the inside of the valve body.
• Caps with flat ends and a hole through the center are
installed with the smaller hole toward the inside of
the valve body.
TOWARD OUTSIDE OF VALVE BODY
TOWARD INSIDE OF VALVE BODY
Main Menu
Table of Contents
Secondary Valve Body
SPRING SPECIFICATIONS
Disassembly/lnspection/Reassembly
NOTE:
• Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air.
• Blow out all passages.
• Check all valves for free movement. If any fail to slide freely, see Valve Body Repair on page
• Coat all parts with ATP during assembly.
• Install the filters in the direction shown.
Main Menu
Table of Contents
Main Valve Body
Disassembly/Inspection/Reassembly
NOTE:
Clean all parts thoroughly in solvent or carburetor cleaner, and dry them with compressed air.
Blow out all passages.
Replace the valve body as an assembly if any parts are worn or damaged.
Check all valves for free movement. If any fail to slide freely, see Valve Body Repair on page
Coat all parts with ATP during assembly.
Install the filters in the direction shown.
CAUTION: Do not use a magnet to remove the check balls; it may magnetize them.
4-3 KICK-DOWN VALVE
3-4 SHIFT VALVE
MANUAL VALVE
MAIN VALVE BODY
Inspect for wear, scratches,
and scoring.
FILTER
Replace
MAIN ORIFICE
CONTROL VALVE
2-3 SHIR VALVE
VALVE CAP
ROLLER
VALVE
CAP
CLIP
SPRING SEAT
1-2 SHIFT VALVE
FILTER
Replace.
CHOKE
CHECK BALLS, 9
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст