Acura RL (1996-2004 year). Manual — part 676
Forced Starting of Display
'96 - 99 Models
1. Pull back the front corner of the right trunk side
trim.
2. Connect the SCS service connector to the naviga-
tion service check connector (2P).
SCS SERVICE CONNECTOR
3. Press and hold the ENTER key, press and hold the
joystick toward the upper left corner, then turn the
ignition switch to ACC (I).
4. Check that the diagnosis menu for the picture diag-
nosis starts up and changes to the system link
screen.
SCS SERVICE CONNECTOR
'00 - 04 Models
1. Pull back the front corner of the right trunk side
trim.
2. Connect the SCS service connector to the naviga-
tion service check connector (2P).
3. Press and hold the CANCEL key, press and hold the
joystick up, then turn the ignition switch to ACC (I).
4. Check that the diagnosis menu for the picture diag-
nosis starts up and changes to the system link
screen.
Main Menu
Table of Contents
5. Insert the new hard disk.
6. Slide the front cover down.
NOTE: After servicing, the front cover must be
down. If you start up the navigation system with the
front cover up, the display will indicate "NO Hard
Disk".
Hard Disk ('96 - 99 Models)
Replacement
1. Turn the ignition switch OFF.
2. Slide the front cover of navigation unit up.
FRONT COVER
DVD-ROM ('00 - 01
Models)
Replacement
1. Turn the ignition switch ON (II).
2. Open the front cover of the navigation unit.
3. Press the EJECT switch.
EJECT SWITCH
FRONT COVER
4. Remove the DVD-ROM.
5. Insert the new DVD-ROM.
6. Close the front cover.
NOTE: After servicing, the front cover must be
closed. If you start up the navigation system with
the front cover open, the display will indicate
"Navigation unit door is open or No DVD Disk
installed. Please check system".
Do not turn the ignition switch OFF until data is
downloaded to navigation unit.
EJECT SWITCH
3. Press the EJECT switch.
NOTE: Make sure the ignition switch is OFF.
4. Remove the hard disk.
HARD DISK
Main Menu
Table of Contents
3. Install in the reverse order of removal.
Navigation Unit/GPS Antenna
Removal/Installation
The illustration shows '00 - 01 models.
Navigation Unit
1. Remove the navigation unit bracket from the trunk.
NAVIGATION UNIT
6 mm NUT
9.8 N-m (1.0 kgf-m,
7 Ibf-ft)
SCREW
BRACKET
2. Remove the navigation unit from the bracket.
3. Install in the reverse order of removal.
GPS Antenna
1. Remove the rear package shelf (see
).
2. Remove the GPS antenna from the package shelf.
GPS ANTENNA
Main Menu
Table of Contents
4. Install in the reverse order of removal.
Display Unit
Removal/Installation
'96 - 99 Models
1. Remove the display unit, audio unit and climate control unit as an assembly.
2. Remove the display unit and audio unit from the frame.
3. Remove the display unit from the audio unit.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст