Acura RL (1996-2004 year). Manual — part 695
DTC 9-1 or No Code (cont'd)
(B)
Troubleshooting - '96 - 98 Models
(C)
(D)
(E)
Main Menu
Table of Contents
Troubleshooting - '96 - 98 Models
DTC 9-1 or No Code (cont'd)
(D)
The problem has disappeared due to disconnecting and
connecting the connectors. Be sure all terminals make
good contact, and recheck the system (see Trouble-
shooting intermittent Failures on page
).
(E)
Main Menu
Table of Contents
DTC 9-2
CAUTION: Whenever the ignition switch is ON (II), or has
been turned OFF for less than 3 minutes, be careful not
to bump the SRS unit; the airbags could accidentally
deploy and cause damage or injuries.
NOTE: The PCM memory must be reset after reconnect-
).
The problem has disappeared. Test-drive the vehicle and
see Troubleshooting Intermittent Failures on page
Check for short to ground between the under-dash fuse/
relay box and the SRS unit.
1. Turn the ignition switch OFF.
2. Disconnect the battery negative cable, then disconnect
the positive cable, and wait for 3 minutes.
3. Disconnect the driver's and front passenger's airbag con-
nectors, then disconnect the driver's and front passen-
ger's seat belt tensioner connectors (see page
).
4. Disconnect the SRS main harness 18P connector from
the SRS unit.
5. Check resistance between the No. 3 terminal of SRS
main harness 18P connector and ground. There should
be 1 or more.
(B)
Faulty SRS unit; replace the SRS unit (see page
).
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст