Acura RL (1996-2004 year). Manual — part 656
*1: '96-97 models
*2: '98 - 00 models
UNDER-HOOD RELAY
BOX B
DRIVER'S POWER WINDOW MOTOR
RELAY B*
2
POWER WINDOW MASTER
SWITCH RELAY*
2
POWER WINDOW MASTER SWITCH RELAY*
Test, page
DRIVER'S POWER WINDOW
MOTOR RELAY A*
2
Test, page
UNDER-HOOD RELAY
BOXC
Main Menu
Table of Contents
Power Windows
Troubleshooting
NOTE:
• Before testing, go to the Troubleshooting Guide (see page
). Be sure to go through self-diagnosis function
and
).
• The numbers in the table show the troubleshooting sequence.
'96 - 97 models: '98 model: '99 - 01 models:
No. 17 (20 A) No. 17 (7.5 A) No. 17 (7.5 A)
No. 18 (20 A) No. 18 (30 A) No. 18 (20 A)
No. 21 (20 A) No. 21 (30 A) No. 21 (20 A)
No. 24 (20 A) No. 24 (30 A) No. 24 (20 A)
Main Menu
Table of Contents
Control Unit Input Test
NOTE:
• Before testing, go to the Troubleshooting Guide (see page
). Be sure to go through self-diagnosis function
and
).
• All connector views are from the wire side of female terminals unless otherwise noted.
Multiplex Control Unit (Driver's):
1. Remove the under-dash fuse/relay box (see page
).
2. Remove the driver's unit from the under-dash fuse/relay box (see page
).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector and the fuse/relay box socket.
— If any test indicates a problem, find and correct the cause, then recheck the system.
— If all the input tests prove OK, the control unit must be faulty; replace it.
Disconnect the connectors from the removed driver's unit.
Cavity Wire Test condition Test: Desired result Possible cause if result is not obtained
Fuse/relay
box socket
Main Menu
Table of Contents
Power Windows
Control Unit Input Test (cont'd)
NOTE:
• Before testing, go to the Troubleshooting Guide (see page
). Be sure to go through self-diagnosis function
and
).
• All connector views are from the wire side of female terminals unless otherwise noted.
Multiplex Control Unit (Door):
1. Remove the driver's door panel, and disconnect the 20P connector from the door unit (see page
).
2. Inspect the connector and socket terminals to be sure they are all making good contact.
• If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
• If the terminals look OK, make the following input tests at the connector.
If any test indicates a problem, find and correct the cause, then recheck the system.
If all the input tests prove OK, the power window master switch must be faulty; replace it.
Main Menu
Table of Contents
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст