Acura TSX / Honda Accord CL. Manual — part 406
Fig. 18: Removing The Bracket Plate
46. Remove the vacuum hose (A) from the vacuum line. Remove the front mount stop (B) and vacuum hose
clamp bracket (C), then remove the front mount bolt (D).
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 19: Removing The Front Mount Stop
47. Remove the rear mount stop (A), then remove the rear mount bolt (B).
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 20: Removing The Rear Mount Stop
48. Check that the engine/transmission is completely free of vacuum hoses, fuel and coolant hoses, and
electrical wiring.
49. Slowly raise the engine about 150 mm (6 in.). Check once again that all hoses and wire are disconnected
from the engine/transmission.
50. Raise the engine and transmission assembly all the way, and remove it from the vehicle.
ENGINE INSTALLATION
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
1. Install the accessory brackets and tighten their bolts and nuts to the specified torques.
Fig. 21: Installing The Accessory Brackets
2. Install the engine and transmission assembly into position in the vehicle, then remove the engine tilt
hanger set from the engine.
NOTE:
Reinstall the mounting bolts/support nuts in the sequence given. Failure to
follow this sequence may cause excessive noise and vibration, and reduce
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст