Acura TSX / Honda Accord CL. Manual — part 768
Fig. 25: Removing Trailing Arm Mounting Bolt
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2004 Acura TSX
2004 SUSPENSION Rear - TSX
Fig. 26: Removing Lower Arm Mounting Bolt
Courtesy of AMERICAN HONDA MOTOR CO., INC.
STABILIZER BAR
Removal & Installation
1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. Remove the rear
wheels.
2. Disconnect the stabilizer links from the stabilizer bar (A) on the right and left. See STABILIZER
LINK . See Fig. 27 .
3. Remove the flange bolts and bushing holders (B), then remove the bushing (C) and the stabilizer bar.
4. Install the stabilizer bar in the reverse order of removal, and note the following items:
z
Make sure the right and left ends of the stabilizer bar are installed on their respective sides of the
vehicle.
z
Align the ends of the paint marks (A) on the stabilizer bar with the bushing (B). See Fig. 28 .
z
See STABILIZER LINK to connect the stabilizer to the links.
2004 Acura TSX
2004 SUSPENSION Rear - TSX
Fig. 27: Disconnecting Stabilizer Links
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2004 Acura TSX
2004 SUSPENSION Rear - TSX
Fig. 28: Aligning Ends Of Paint Marks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
STABILIZER LINK
Removal & Installation
1. Raise the rear of the vehicle, and make sure it is securely supported. Remove the rear wheels.
2. Remove the self-locking nut (A) and flange nut (B) while holding the respective joint pins (C) with a hex
wrench (D), and remove the stabilizer link (E). See Fig. 29 .
NOTE:
The left stabilizer link has a White paint mark (D), while the right stabilizer
link has a Yellow painting mark.
2004 Acura TSX
2004 SUSPENSION Rear - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст