Acura TSX / Honda Accord CL. Manual — part 6
Fig. 24: Identifying Connectors & Terminals
Fig. 25: Identifying Stereo Amplifier Connector A Terminal Wiring Table
Fig. 26: Identifying Stereo Amplifier Connector B Terminal Wiring Table
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Audio System - TSX
AUDIO-HVAC SUBDISPLAY/CLOCK CONNECTOR REPLACEMENT
When replacing an audio unit connector, match the wires to the cavities listed in the following table. See Fig.
27 and Fig. 28 .
Fig. 27: Identifying Connectors & Terminals (With Navigation)
Fig. 28: Identifying Audio-HVAC Subdisplay/Clock Connector Terminal Wiring Table
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Audio System - TSX
AUDIO-HVAC SUBDISPLAY/CLOCK REPLACEMENT
1. Remove the Audio-HVAC Display Module (see AUDIO-HVAC DISPLAY MODULE
REMOVAL/INSTALLATION ).
2. Remove the two mounting screws.
3. Disconnect the 10P connector (A) from the sub display unit (B).
Fig. 29: Removing Audio-HVAC Subdisplay/Clock
4. Install in the reverse order of removal.
AUDIO-HVAC DISPLAY MODULE REMOVAL/INSTALLATION
SRS components are located in this area. Review the SRS component locations, and the precautions and
procedures in the SRS before performing repairs or service. See AIR BAG RESTRAINT SYSTEMS .
NOTE:
z
Put on gloves to protect your hands.
z
Take care not to scratch the dashboard and related parts.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Audio System - TSX
1. Make sure you have the anti-theft codes for the radio and navigation system, then write down the
frequencies for the radio's preset buttons.
2. Remove the driver's inner dashboard trim (see DRIVER'S INNER DASHBOARD TRIM
REMOVAL/INSTALLATION ) and passenger's dashboard trim (see PASSENGER'S DASHBOARD
TRIM REMOVAL/INSTALLATION ).
3. Remove the hazard warning switch.
4. Remove the screws and bolts. Disconnect the audio-HVAC-display module connectors (A) and the
antenna lead (B), then remove the audio-HVAC display module.
z
Lay a workshop towel under the parts when working on them to protect
the face panel from scratches or other damage.
z
Do not work in a dusty or dirty environment.
z
Discharge static electricity from your body before and during the work.
z
Do not touch the circuit board with your bare hands.
z
Be careful not to fold the flat plate cable.
z
Do not touch the terminal connector of the flat plate cable with your bare
hands. (If you have touched it, wipe it off thoroughly.)
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Audio System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст