Acura TSX / Honda Accord CL. Manual — part 954
Fig. 126: Measuring The Voltage Between PCM Connector Terminals C19 & A8 Or A9
24. Measure the voltage between PCM connector terminals A21 and A8 or A9.
Is there 4.75 V-5.25 V?
YES: Repair open in the wire between PCM connector terminal A21 and the mainshaft speed
sensor connector, then go to step 30 .
NO: Go to step 25.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
Fig. 127: Measuring The Voltage Between PCM Connector Terminals A21 & A8 Or A9
25. Turn the ignition switch OFF.
26. Jump the SCS line with the HDS.
27. Disconnect PCM connector A (31P).
28. Check for continuity between PCM connector terminal A21 and body ground.
Is there continuity?
YES: Repair short to ground in the wire between PCM connector terminal A21 and the
mainshaft speed sensor connector, then go to step 30 .
NO: Check for loose or poor connections at PCM connector terminal A21. If the connection
is OK, update the PCM if it does not have the latest software, or substitute a known-good
PCM (see PCM UPDATING & SUBSTITUTION FOR TESTING ), then recheck. If the
symptom/indication goes away with a known-good PCM, replace the original PCM.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
Fig. 128: Checking For Continuity Between PCM Connector Terminal A21 & Body Ground
29. Measure the voltage between PCM connector terminals C19 and A8 or A9.
Is there about 5 V?
YES: Repair open in the wire between PCM connector terminal C19 and the mainshaft speed
sensor connector, then go to step 30.
NO: Check for loose or poor connections at PCM connector terminal C19. If the connection
is OK, update the PCM if it does not have the latest software, or substitute a known-good
PCM (see PCM UPDATING & SUBSTITUTION FOR TESTING ), then recheck. If the
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
symptom/indication goes away with a known-good PCM, replace the original PCM.
Fig. 129: Measuring The Voltage Between PCM Connector Terminals C19 & A8 Or A9
30. Clear the DTC with the HDS.
31. Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data.
32. Check the OBD STATUS in DTCs MENU for a pass/fail test of code P0717.
Did the result indicate a pass?
YES: The problem has been corrected.
NO: Return to step 1 and recheck.
DTC P0718: MAINSHAFT SPEED SENSOR INTERMITTENT FAILURE
1. Clear the DTC with the HDS.
2. Test-drive the vehicle for several minutes in the D position in all five gears.
NOTE:
z
Record all freeze data and review General Troubleshooting Information
(see GENERAL TROUBLESHOOTING INFORMATION ) before you
troubleshoot.
z
This code is caused by an electrical circuit problem and cannot be caused
by a mechanical problem in the transmission.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст