Acura TSX / Honda Accord CL. Manual — part 203
Fig. 76: Removing The Cylinder Lines From The Gearbox
9. Drain the fluid from the cylinder fittings by slowly moving the steering rack back and forth.
10. Remove the two flange bolts, then remove the valve body unit (A) from the gearbox (B). Remove the O-
ring (C), and discard it.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 77: Removing The Valve Body Unit From The Gearbox
11. Drill a 3 mm (0.12 in.) diameter hole about 2.5-3.0 mm (0.10-0.12 in.) in depth in the staked point (A) on
the cylinder. Do not allow metal shavings to enter the cylinder side on the gearbox housing. After
removing the cylinder end (B), remove any burrs at the staked point.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 78: Drilling A Hole In The Staked Point On The Cylinder
12. Hold the gearbox housing using a C-clamp (commercially available) (A) and the wooden blocks (B) as
shown. Do not clamp the cylinder part of the gearbox housing in the vise. Then remove the cylinder end
(C).
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Fig. 79: Holding The Gearbox Housing Using A C-Clamp & The Wooden Blocks
13. Install a commercially available bearing separator (A) in the gearbox housing as shown.
2004 Acura TSX
2004 STEERING Power Steering System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст