Acura TSX / Honda Accord CL. Manual — part 89

Fig. 34: Removing The Upper Edge Of The Door Outer Molding

3. Scrape off the remaining double-sided adhesive tape from the sash, then clean the sash surface with a

sponge dampened in alcohol.

4. Install a new door outer molding in the reverse order of removal, and note these items:

z

Push the clip and the adhesive portions into place securely.

z

Make sure the upper and lower sides of the molding are catching the edges of the sash properly.

FRONT DOOR WEATHERSTRIP REPLACEMENT

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

1. At the A-pillar, remove the door stop mounting bolt (A).

NOTE:

z

Take care not to scratch the door.

z

Use a clip remover to remove the clips.

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

Fig. 35: Removing The Door Weatherstrip

2. Detach the clips (B, C, D), then remove the door weatherstrip (E).

3. Install the weatherstrip in the reverse order of removal and note these items:

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX

z

Replace any damaged clips.

z

Make sure the weatherstrip is installed in the holder (F) securely.

z

Apply liquid thread lock to door stop mounting bolt before installation.

z

Check for water leaks (see step 7 of FRONT & REAR DOOR GLASS ADJUSTMENT ).

REAR DOOR PANEL REMOVAL/INSTALLATION

Special Tools Required: Trim pad remover, Snap-on A 177A or equivalent, commercially available.

1. Lower the glass fully.

2. Using a flat-tip screwdriver wrapped with protective tape, push on the rear hook (A) and pivot the cover

(B) on the front hook (C), then remove the cover and the screws securing the inner handle (D).

Fig. 36: Removing The Cover And The Screws Securing The Inner Handle

3. Remove the switch panel (A).

a. Pry up on the front edge of the switch panel with a flat-tip screwdriver wrapped with protective

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX