Acura TSX / Honda Accord CL. Manual — part 787

1. Remove the bolt, then remove the lock washer (A) and bearing set plate (B).

Fig. 51: Removing The Bolt, The Lock Washer And Bearing Set Plate

2. Remove the secondary shaft bearing (A) by heating the housing to about 212°F (100°C) with a heat gun

(B). Do not heat the housing in excess of 212°F (100°C).

NOTE:

Let the housing cool to normal temperature before installing the bearing.

2004 Acura TSX

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

Fig. 52: Removing The Secondary Shaft Bearing By Heating The Housing With A Heat Gun

3. Install the new O-rings (A) on the ATF guide collar (B), then install the ATF guide collar in the housing.

2004 Acura TSX

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

Fig. 53: Installing The New O-Rings On The ATF Guide Collar, Then Installing The ATF Guide
Collar In The Housing

4. Install the new secondary shaft bearing (C) in the direction shown.

5. Drive the secondary shaft bearing with the special tools, and install it securely in the housing.

2004 Acura TSX

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX

Fig. 54: Driving The Secondary Shaft Bearing

6. Check that the bearing groove aligns with the housing surface, then install the bearing set plate with

aligning the bearing groove.

7. Install the new lock washer and bolt, then bend the lock tab of the lock washer against the bolt head.

CONTROL SHAFT OIL SEAL REPLACEMENT

Special Tools Required

z

Driver 07749-0010000

z

Oil seal driver attachment 07947-ZV00100

1. Remove the oil seal (A) from the torque converter housing (B).

2004 Acura TSX

2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX