Acura TSX / Honda Accord CL. Manual — part 147
Fig. 16: DTC Table
8. Check for B-CAN DTCs indicated by the gauge control module while still in Test Mode 1.
Are any DTCs indicated?
YES: Go to step 9.
NO: Go to step 11 .
9. Record all DTCs and sort them by type using the DTC Troubleshooting Index.
10. Troubleshoot the DTCs in the following order:
z
Battery voltage DTCs
z
Internal error DTCs
z
Loss of communication DTCs (begin with the lowest number first; for example, if B1006 and
B1059 are retrieved, troubleshoot B1006 first)
z
Signal error DTCs
11. Remove the MPCS service connector from the under-dash fuse/relay box socket for 5-10 seconds, then
re-insert it.
NOTE:
If the MPCS connector is disconnected for too short or too long of a time,
or the ignition switch is turned OFF, the system will return to Test Mode 2.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX
12. In the table below is a list of circuits that can be checked in Test Mode 2. Operate the switch that is most
closely related to the problem. If the circuit is OK, the ceiling light will blink once. If the circuit is faulty,
there will be no indication.
Does the ceiling light indicate proper switch operation?
YES: Go to function and input test for the system related to the failure.
NO: Repair the open, short, or replace the faulty switch.
Fig. 17: MICU Table
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX
Fig. 18: Relay Control Module Table
Fig. 19: Combination Switch Control Unit Table
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX
Fig. 20: Power Window Master Switch (Door Multiplex Control Unit) Table
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Multiplex Integrated Control System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст