Acura TSX / Honda Accord CL. Manual — part 17
Fig. 6: Cruise Control Input Tests (2 Of 2)
CRUISE CONTROL COMBINATION SWITCH TEST/REPLACEMENT
1. Remove the driver's airbag (see AIR BAG RESTRAINT SYSTEMS ).
2. Remove the two screws, then disconnect the connector, and remove the switch.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX
Fig. 7: Removing Cruise Control Combination Switch
3. Check for continuity between the terminals in each switch position according to the table.
z
If there is continuity, and it matches the table, but switch failure occurred on the cruise control unit
input test, check and repair the wire harness on the switch circuit.
z
If there is no continuity in one or both positions, replace the switch.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX
Fig. 8: Cruise Control Combination Switch Continuity Table
CLUTCH PEDAL POSITION SWITCH TEST
1. Disconnect the 3P connector from the clutch pedal position switch (A).
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX
Fig. 9: Disconnecting The 3P Connector From The Clutch Pedal Position Switch
2. Remove the clutch pedal position switch.
3. Check for continuity between the terminals according to the table.
z
If the continuity is not as specified, replace the clutch pedal position switch.
z
If OK, install the clutch pedal position switch and adjust the pedal height (see CLUTCH PEDAL,
CLUTCH PEDAL POSITION SWITCH, A ).
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Cruise Control - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст