Acura TSX / Honda Accord CL. Manual — part 282
Fig. 45: Checking For Continuity Between Body Ground & The VSA Control Unit 47P
Connector Terminals No. 33, No. 35 & No. 37
12. Check for continuity between the VSA control unit 47P connector terminal No. 35 and yaw rate-lateral
acceleration sensor 5P connector terminal No. 2.
Is there continuity?
YES: Go to step 13.
NO: Repair open in the wire between the VSA control unit and the yaw rate-lateral
acceleration sensor.
2004 Acura TSX
2004 BRAKES Vehicle Stability Assist System - TSX
Fig. 46: Checking For Continuity Between The VSA Control Unit 47P Connector & Yaw
Rate-Lateral Acceleration Sensor 5P Connector
13. Check for continuity between the VSA control unit 47P connector terminal No. 33 and yaw rate-lateral
acceleration sensor 5P connector terminal No. 4.
Is there continuity?
YES: Go to step 14.
NO: Repair open in the wire between the VSA control unit and the yaw rate-lateral
acceleration sensor.
2004 Acura TSX
2004 BRAKES Vehicle Stability Assist System - TSX
Fig. 47: Checking For Continuity Between The VSA Control Unit 47P Connector & Yaw
Rate-Lateral Acceleration Sensor 5P Connector
14. Check for continuity between the VSA control unit 47P connector terminal No. 37 and yaw rate-lateral
acceleration sensor 5P connector terminal No. 5.
Is there continuity?
YES: Go to step 15.
NO: Repair open in the wire between the VSA control unit and the yaw rate-lateral
acceleration sensor.
2004 Acura TSX
2004 BRAKES Vehicle Stability Assist System - TSX
Fig. 48: Checking For Continuity Between The VSA Control Unit 47P Connector & Yaw
Rate-Lateral Acceleration Sensor 5P Connector
15. Substitute a known-good yaw rate-lateral acceleration sensor.
16. Reconnect all of the disconnected connectors.
17. Clear the DTC using the HDS (see HOW TO CLEAR DTCS ).
18. Disconnect the HDS from the 16P DLC.
19. Turn the ignition switch OFF, then turn it ON (II) again.
20. Test-drive the vehicle around a number of corners.
21. Verify the DTC.
Is DTC 25 indicated?
YES: Replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL
UNIT REMOVAL & INSTALLATION ).
NO: Replace the original yaw rate-lateral acceleration sensor (see YAW RATE-LATERAL
ACCELERATION SENSOR REPLACEMENT ).
DTC 27: STEERING ANGLE SENSOR
1. Clear the DTC using the HDS (see HOW TO CLEAR DTCS ).
2004 Acura TSX
2004 BRAKES Vehicle Stability Assist System - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст