Acura TSX / Honda Accord CL. Manual — part 819
Fig. 169: Checking The Backlash Of The Pinion Gears With A Dial Indicator
2. Check the backlash of the pinion gears (A) with a dial indicator (B).
Standard: 0.05-0.15 mm (0.002-0.006 in.)
3. If the backlash is out of standard, replace the differential carrier.
CARRIER BEARING REPLACEMENT
Special Tools Required
Attachment, 40 x 50 mm 07LAD-PW50601
NOTE:
z
The bearing and bearing outer race should be replaced as a set.
z
Inspect and adjust the carrier bearing preload whenever bearing is
replaced.
z
Check the bearing for wear and rough rotation. If the bearing is OK,
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
1. Remove the carrier bearing (A) with a commercially available puller (B), bearing separator (C), and
stepped adapter (D).
Fig. 170: Removing The Carrier Bearing
2. Install the NEW bearings with the special tool using the small end and a press until it bottoms. Press the
bearing on securely so there is no clearance between the bearing and the differential carrier.
removal is not necessary.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 171: Installing The NEW Bearings
DIFFERENTIAL CARRIER, FINAL DRIVEN GEAR REPLACEMENT
1. Remove the final driven gear from the differential carrier, and replace the differential carrier or final
driven gear.
2. Install the final driven gear (A) in the direction shown on the differential carrier (B).
NOTE:
Differential carrier bolts have left-hand threads.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 172: Installing The Final Driven Gear On The Differential Carrier
OIL SEAL REPLACEMENT
Special Tools Required
z
Driver 07749-0010000
z
Oil seal driver attachment 07947-SD90101
z
Oil seal driver attachment 07JAD-PH80101
1. Remove the oil seal from the transmission housing.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст