Acura TSX / Honda Accord CL. Manual — part 815
12. Tighten the locknuts to 167 N.m (17.0 kgf.m, 123 lbf.ft).
13. Remove the special tool from the mainshaft.
14. Stake the locknuts into the shafts with a punch.
Fig. 153: Staking The Locknuts Into The Shafts With A Punch
15. Install the control level (A) on the control shaft (B), and install the bolt with the new lock washer (C),
then bend the lock tab of the lock washer against the bolt head.
NOTE:
z
Be sure to install the conical spring washers in the direction shown.
z
Use a torque wrench to tighten the locknut. Do not use an impact
wrench.
z
Countershaft and secondary shaft locknuts have left-hand threads.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 154: Installing The Control Level On The Control Shaft
16. Set the park lever in the P position, then verify that the park pawl (A) engages the park gear (B).
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 155: Verifying The Park Pawl Engages The Park Gear
17. If the park pawl does not engage fully, check the distance (C) between the pawl shaft (D) and the park
lever roller pin (E) (see page 14-256).
18. Tighten the lock bolt, and bend the lock tab of the lock washer (F) against the bolt head.
19. Install the ATF feed pipe (A) into the idler gear shaft, and install the ATF lubrication pipe (B) into the
transmission housing.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Fig. 156: Installing The ATF Feed Pipe & The ATF Lubrication Pipe
20. Install the new gasket (A) on the transmission housing, and install the two dowel pins (B) and new O-
rings (C) over the top of the ATF feed pipes.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS A/T Overhaul (MCTA) - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст