Acura TSX / Honda Accord CL. Manual — part 136

Fig. 16: Removing Front & Rear Sunshade Base Sliders

8. Install the sunshade in the reverse order of removal, and check the glass height adjustment (see GLASS

REPLACEMENT ).

9. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure

spray.

MOTOR REPLACEMENT

1. Remove the headliner (see HEADLINER REMOVAL/INSTALLATION ).

2. Put on gloves to protect your hands. Disconnect the connector (A), and remove the bolts, then remove the

motor (B).

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Moonroof - TSX

Fig. 17: Removing The Motor

3. Install the motor in the reverse order of removal, and note these items:

z

Make sure the connector is plugged in properly.

z

Check the motor operation.

FRAME & DRAIN TUBE REPLACEMENT

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Moonroof - TSX

SRS components are located in this area. Review the SRS component locations, and the precautions and
procedures in the SRS section before performing repairs or service. See AIR BAG RESTRAINT SYSTEMS .

1. Remove these items:

z

Headliner (see HEADLINER REMOVAL/INSTALLATION )

z

Moonroof glass (see GLASS REPLACEMENT )

z

Without side curtain airbag: Rear grab handle bracket, both sides (see step 7 of HEADLINER
REMOVAL/INSTALLATION )

z

Without side curtain airbag: Roof side pad, front and rear both sides (see step 8 of HEADLINER
REMOVAL/INSTALLATION )

2. With side curtain airbag: Remove the bolts securing both rear grab handle brackets (A), then release them

from the body. Do not pull the bracket with the airbag excessively. Take care not to damage the airbag.

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Moonroof - TSX

Fig. 18: Removing The Bolts Securing Both Rear Grab Handle Brackets

3. Put on gloves to protect your hands. Disconnect the motor connector (A), open/close-tilt/close switch

2004 Acura TSX

2004 ACCESSORIES & EQUIPMENT Moonroof - TSX