Acura TSX / Honda Accord CL. Manual — part 995
Fig. 233: Disconnecting The A/T Clutch Pressure Control Solenoid Valve A Connector
7. Measure A/T clutch pressure control solenoid valve A resistance at the solenoid valve A connector.
Standard: 3-10 ohm
8. If the resistance is out of standard, replace the A/T clutch pressure control solenoid valve A.
9. Connect the battery positive terminal to the No. 1 terminal of the A/T clutch pressure control solenoid
valve A connector, and connect the battery negative terminal to the No. 2 terminal. A clicking sound
should be heard.
10. If no sound is heard, remove the A/T clutch pressure control solenoid valve A.
11. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust or dirt.
12. Connect the No. 1 terminal of the A/T clutch pressure control solenoid valve A connector to the battery
positive terminal, and connect the No. 2 terminal to the battery negative terminal. Make sure the A/T
clutch pressure control solenoid valve moves.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
Fig. 234: Checking A/T Clutch Pressure Control Solenoid Valve Movement
13. Disconnect one of the battery terminals and check for valve movement.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
14. If the valve binds or moves sluggishly, or if the solenoid valve does not operate, replace the A/T clutch
pressure control solenoid valve A.
A/T CLUTCH PRESSURE CONTROL SOLENOID VALVE A REPLACEMENT
1. Remove the intake air duct.
2. Disconnect the A/T clutch pressure control solenoid valve A connector.
3. Remove the bolts securing the ATF cooler inlet line brackets (B) from the transmission hanger (C).
NOTE:
You can see valve movement through the fluid passage in the mounting
surface of the A/T clutch pressure control solenoid valve A body.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
Fig. 235: Removing Components
4. Remove the mounting bolts and the A/T clutch pressure control solenoid valve A.
5. Remove the ATF pipe (D), ATF joint pipes (E), O-rings (F), and gasket (G).
6. Clean the mounting surface and fluid passages of the transmission housing.
7. Install the new gasket on the transmission housing, and install the ATF pipe and ATF joint pipes.
8. Install the new O-rings over the ATF joint pipes.
2004 Acura TSX
2004 AUTOMATIC TRANSMISSIONS Diagnosis - MCTA 5-Speed
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст