Acura TSX / Honda Accord CL. Manual — part 83
courtesy light bulb socket (C), and detach the harness clip (D). Passenger's door panel is shown; driver's
door panel is similar.
Fig. 11: Disconnecting The Inner Handle Cable, Power Door Lock Switch Connector (Passenger's
Door), Courtesy Light Bulb Socket & Detaching The Harness Clip
10. If necessary, remove the door glass inner weatherstrip (A) from the door panel (B) by pulling it down.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Fig. 12: Removing The Door Glass Inner Weatherstrip From The Door Panel
11. If necessary, remove the inner handle (A).
a. Carefully peel the edge of the insulator (B) from the back of the door panel as needed.
b. Remove the screws (C), then remove the door panel trim (D).
c. Remove the screws (E) from the front of the door panel, then remove the inner handle.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Fig. 13: Removing The Inner Handle
12. Install the door panel in the reverse order of removal, and note these items:
z
Replace any damaged clips.
z
Make sure the connectors are plugged in properly, and the cable and the bulb socket are connected
properly.
z
Make sure the window and power door lock operate properly.
FRONT DOOR OUTER HANDLE REPLACEMENT
1. Remove these items:
NOTE:
Put on gloves to protect your hands.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
a. Door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION )
b. Plastic cover, as necessary (see COMPONENT LOCATION INDEX )
2. Raise the glass fully.
3. Remove the maintenance hole seal (A), then disconnect the outer handle rod (B).
Fig. 14: Removing The Maintenance Hole Seal, Then Disconnecting The Outer Handle Rod
4. Pull the glass run channel (A) away as needed, and remove the bolt, then remove the center lower channel
by pulling it downward.
2004 Acura TSX
2004 ACCESSORIES & EQUIPMENT Interior Trim - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст