Acura TSX / Honda Accord CL. Manual — part 439
Fig. 147: Driving The Guide In To The Specified Installed Height
10. Coat both reamer and valve guide with cutting oil.
11. Rotate the reamer clockwise the full length of the valve guide bore.
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 148: Reaming The Valve Guide
12. Continue to rotate the reamer clockwise while removing it from the bore.
13. Thoroughly wash the guide in detergent and water to remove any cutting residue.
14. Check the clearances with a valve (see VALVE STEM-TO-GUIDE CLEARANCE INSPECTION ).
Verify that a valve slides in the intake and exhaust valve guides without exerting pressure.
VALVE SEAT RECONDITIONING
1. Inspect valve stem-to-guide clearance (see VALVE STEM-TO-GUIDE CLEARANCE
INSPECTION ). If the valve guides are worn, replace them (see VALVE GUIDE REPLACEMENT )
before cutting the valve seats.
2. Renew the valve seats in the cylinder head using a valve seat cutter.
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 149: Using A Valve Seat Cutter
3. Carefully cut a 45° seat, removing only enough material to ensure a smooth and concentric seat.
4. Bevel the upper and lower edges at the angles shown in the illustration. Check the width of the seat and
adjust accordingly.
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Fig. 150: Beveling The Upper & Lower Edges
5. Make one more very light pass with the 45° cutter to remove any possible burrs caused by the other
cutters.
Valve Seat Width:
Standard (New): 1.25-1.55 mm (0.049-0.061 in.)
Service Limit: 2.00 mm (0.079 in.)
6. After resurfacing the seat, inspect for even valve seating: Apply Prussian Blue compound (A) to the valve
face. Insert the valve in its original location in the head, then lift it and snap it closed against the seat
2004 Acura TSX
2004 ENGINES 2.4L DOHC VTEC - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст