Acura TSX / Honda Accord CL. Manual — part 301
Fig. 19: Wrapping Joint Splines With Vinyl Tape
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disassembly (Outboard Joint)
1. Remove the boot bands. Be careful not to damage the boot and dynamic damper. See Fig. 20 . If the boot
band is an ear clamp type (B), lift up the three tabs (A) with a screwdriver.
2. Slide the outboard boot (B) partially to the inboard joint side. Be careful not to damage the boot. See Fig.
21 .
3. Wipe off the grease to expose the axle shaft and the outboard joint inner race.
4. Make a mark (A) on the axle shaft (B) at the same position of the outboard joint end (C). See Fig. 22 .
5. Carefully clamp the axle shaft in a vise.
6. Remove the outboard joint (A) using the threaded adapter and a commercially available 5/8" slide
hammer (B). See Fig. 23 .
7. Remove the axle shaft from the vise.
8. Remove the stop ring from the axle shaft. See Fig. 24 .
2004 Acura TSX
2004 DRIVE AXLES Axle Shafts - Front - TSX
9. Wrap the splines on the axle shaft with vinyl tape to prevent damage to the boot. See Fig. 19 .
10. Remove the outboard boot. Be careful not to damage the boot.
11. Remove the vinyl tape.
Fig. 20: Removing Outboard Joint Side Boot Bands
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2004 Acura TSX
2004 DRIVE AXLES Axle Shafts - Front - TSX
Fig. 21: Removing Outboard Boot
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2004 Acura TSX
2004 DRIVE AXLES Axle Shafts - Front - TSX
Fig. 22: Marking Axle Shaft
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2004 Acura TSX
2004 DRIVE AXLES Axle Shafts - Front - TSX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст